Details

---

BUY MAX153EAP https://www.utsource.net/itm/p/129649.html
1Msps, レP-Compatible, 8-Bit ADC with 1レA Power-Down

Parameter	Symbol	Conditions	Min	Typical	Max	Unit
Supply Voltage	VCC	Operating Range	2.7	-	5.5	V
Input Voltage	VIN	Operating Range	0	-	5.5	V
Output Voltage	VOUT	-	0	-	5.5	V
Quiescent Current	IQ	VCC = 5V	-	1.0	-	mA
Shutdown Current	ISD	VCC = 5V, SHDN = 0V	-	1.0	-	μA
Output Current	IOUT	Continuous	-	-	100	mA
Bandwidth	fBW	-	-	400	-	kHz
Slew Rate	SR	-	-	1.0	-	V/μs
Power Supply Rejection Ratio (PSRR)	PSRR	f = 1kHz	60	-	80	dB
Common-Mode Rejection Ratio (CMRR)	CMRR	-	70	-	90	dB
Input Offset Voltage	VOS	-	-1	0	1	mV
Input Bias Current	IB	-	-	50	-	nA
Output Impedance	ZOUT	f = 1kHz	-	0.5	-	Ω

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the operating range of 2.7V to 5.5V.
   • Connect a bypass capacitor (typically 0.1μF) between VCC and GND close to the device to filter out noise.

2. Input Signal:

   • The input signal (VIN) should be within the operating range of 0V to 5.5V.
   • Ensure the input signal does not exceed the supply voltage to avoid damage.

3. Output Configuration:

   • The output voltage (VOUT) can be set by external resistors or through internal configuration, depending on the application.
   • Ensure the load connected to the output does not exceed the maximum output current of 100mA.

4. Shutdown Mode:

   • To put the device into shutdown mode, pull the SHDN pin low (0V).
   • In shutdown mode, the quiescent current drops to approximately 1.0μA.

5. Stability:

   • For stable operation, ensure the feedback network is properly designed to maintain stability over the desired frequency range.
   • Use appropriate compensation components if necessary.

6. Thermal Management:

   • Ensure adequate heat dissipation if the device is operated at high currents or in high ambient temperatures.
   • Consider using a heatsink or thermal pad if necessary.

7. PCB Layout:

   • Keep the power and ground traces short and wide to minimize inductance and resistance.
   • Place decoupling capacitors as close as possible to the power pins.

8. Testing:

   • Before finalizing the design, test the circuit under various conditions to ensure it meets the performance specifications.
   • Monitor the output for stability and accuracy.

By following these guidelines, you can ensure optimal performance and reliability of the MAX153EAP in your application.

(For reference only)