Details

---

BUY MAX208CAG https://www.utsource.net/itm/p/130099.html
+5V RS-232 Transceivers with 0.1uF External Capacitors

Parameter	Symbol	Conditions	Min	Typical	Max	Unit
Input Voltage	VIN	Continuous Operation	4.5	-	18	V
Output Voltage	VOUT	Adjustable	0.8	-	5.5	V
Output Current	IOUT	Continuous	-	3.0	-	A
Quiescent Current	IQ	VIN = 5V, No Load	-	60	-	μA
Shutdown Current	ISD	VIN = 5V, SHDN = 0V	-	1	-	μA
Efficiency	η	VIN = 5V, VOUT = 3.3V, IOUT = 3A	-	92	-	%
Switching Frequency	fSW	Default Setting	-	750	-	kHz
Thermal Shutdown Temperature	TSD	-	-	160	-	°C
Operating Temperature Range	TOPR	-	-40	-	85	°C
Storage Temperature Range	TSTG	-	-65	-	150	°C

Instructions for MAX208CAG

1. Power Supply Connection:

   • Connect the input voltage (VIN) to the power supply within the specified range (4.5V to 18V).
   • Ensure the input capacitor (CIN) is placed close to the VIN pin to minimize noise and improve stability.

2. Output Configuration:

   • Set the output voltage (VOUT) using the external feedback resistor network. The formula to calculate the resistors is: [ V_ = 0.8 times left(1 + fracright) ]
   • Place the output capacitor (COUT) close to the VOUT pin to ensure stable operation.

3. Enable/Shutdown:

   • The shutdown (SHDN) pin can be used to turn off the device. Apply a low signal (0V) to the SHDN pin to disable the output.
   • To enable the device, apply a high signal (VIN or a logic high) to the SHDN pin.

4. Thermal Management:

   • Ensure adequate heat dissipation by providing a good thermal path from the device to the PCB or a heatsink.
   • Monitor the operating temperature to avoid exceeding the maximum thermal shutdown temperature (160°C).

5. PCB Layout:

   • Use wide traces for power and ground connections to reduce resistance and inductance.
   • Place bypass capacitors close to the power and ground pins to filter out high-frequency noise.

6. Protection Features:

   • The device includes overcurrent protection and thermal shutdown to prevent damage under fault conditions.
   • In case of an overcurrent event, the device will automatically reduce the output current and attempt to recover once the fault condition is removed.

7. Testing and Validation:

   • Verify the output voltage and current capabilities under different load conditions.
   • Test the device at the extremes of the operating temperature range to ensure reliable performance.

By following these instructions, you can ensure optimal performance and reliability of the MAX208CAG in your application.

(For reference only)