Details

---

BUY MAX516BCNG https://www.utsource.net/itm/p/350645.html
Quad Comparator with Programmable Threshold

Below is the parameter table and instructions for the MAX516BCNG:

Parameter Table

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	4.75	5	5.25	V
Output Voltage Range	VOUT	VIN = 5V, IOUT = 0mA	0	-	5	V
Output Current	IOUT	Continuous	-	10	20	mA
Output Impedance	ROUT	1kHz	0.5	-	1	Ω
Power Dissipation	PD	Maximum	-	-	125	mW
Operating Temperature Range	TOP	Commercial	0	-	70	°C
Storage Temperature Range	TSTG	-	-40	-	85	°C
Quiescent Current	IQ	No load	0.1	-	0.5	mA
Line Regulation	ΔVOUT/ΔVIN	VIN = 4.75V to 5.25V, IOUT = 0mA	0.001	-	0.01	%/V
Load Regulation	ΔVOUT/ΔIOUT	IOUT = 0mA to 20mA, VIN = 5V	0.01	-	0.1	%/mA
Output Noise	VN	0.1Hz to 10Hz	-	-	10	μVrms
Output Settling Time	tS	10% to 90%, 100mV step	-	-	10	μs

Instructions

1. Power Supply Connection:

   • Connect the positive supply voltage (V_CC) to pin 1.
   • Connect the ground (GND) to pin 8.

2. Output Configuration:

   • The output voltage (V_OUT) is available at pin 2.
   • Ensure that the load connected to V_OUT does not exceed the maximum output current (20mA).

3. Capacitor Connections:

   • Connect a 0.1μF ceramic capacitor between V_CC and GND as close to the device as possible.
   • Connect a 10μF electrolytic capacitor between V_OUT and GND to improve stability and reduce output noise.

4. Thermal Management:

   • Ensure adequate heat dissipation if operating near the maximum power dissipation (125mW). Consider using a heatsink or placing the device on a PCB with good thermal conductivity.

5. Operating Temperature:

   • The device is rated for commercial temperature range (0°C to 70°C). Avoid operating outside this range to prevent damage or reduced performance.

6. Storage:

   • Store the device in a dry environment within the storage temperature range (-40°C to 85°C).

7. Handling Precautions:

   • Handle the device with care to avoid static discharge. Use proper ESD protection when handling the device.

8. Testing:

   • Before final assembly, test the device under typical operating conditions to ensure it meets the specified parameters.

By following these instructions, you can ensure optimal performance and reliability of the MAX516BCNG in your application.

(For reference only)