Details

---

BUY ML4800IP https://www.utsource.net/itm/p/410688.html
IC PFC CTR AVER CURR 76KHZ 16DIP

Parameter	Description	Value
Package Type	Type of package	SOP-8
Operating Voltage (Vcc)	Supply voltage range	2.7V to 5.5V
Output Current (Iout)	Maximum output current per channel	30mA
Operating Temperature (Tamb)	Ambient temperature range	-40°C to +85°C
Storage Temperature (Tstg)	Storage temperature range	-65°C to +150°C
Input Voltage Range (Vin)	Input voltage range for logic levels	0V to Vcc
Propagation Delay (tPD)	Time delay from input to output	10ns (typical) at Vcc = 5V
Power Dissipation (Pd)	Maximum power dissipation	360mW
ESD Protection	Electrostatic discharge protection	HBM: ±2kV, MM: ±200V
Quiescent Current (Iq)	Current consumption when idle	1μA (typical)
Output Type	Type of output stage	Push-Pull

Instructions for Use

1. Power Supply Connection:

   • Connect the Vcc pin to the positive supply voltage within the specified range (2.7V to 5.5V).
   • Connect the GND pin to the system ground.

2. Input Signal:

   • Apply logic level signals to the input pins. The input voltage should be within the range of 0V to Vcc.
   • Ensure that the input signals are clean and stable to avoid unintended switching.

3. Output Load:

   • Connect the load to the output pins. The maximum current per channel is 30mA.
   • Ensure that the load resistance is appropriate to limit the current to within the specified range.

4. Decoupling Capacitors:

   • Place a 0.1μF ceramic capacitor between Vcc and GND as close to the device as possible to filter out noise and provide stable operation.

5. Thermal Management:

   • Ensure adequate heat dissipation if the device is operating near its maximum power dissipation. This can be achieved by using a heatsink or ensuring good airflow around the device.

6. ESD Handling:

   • Handle the device with ESD precautions to avoid damage. Use grounded wrist straps and static-safe work surfaces.

7. Testing and Debugging:

   • Use a multimeter to verify the supply voltage and output voltages.
   • Use an oscilloscope to check the propagation delay and signal integrity.

8. Storage and Handling:

   • Store the device in a dry, cool place within the specified storage temperature range.
   • Avoid exposing the device to extreme temperatures or humidity.

9. Compliance and Standards:

   • Ensure that the device is used in compliance with relevant safety and regulatory standards.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)