Details

---

BUY AD1866RZ https://www.utsource.net/itm/p/700982.html
Single Supply Dual 16-Bit Audio DAC; Package: SOIC - Wide; No of Pins: 16; Temperature Range: Commercial

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Supply Voltage	VDD	2.7	-	5.5	V	-
Analog Input Voltage	VIN	0	-	VDD	V	Differential input voltage range
Output Data Rate	fODR	4	-	192	kHz	Configurable via SPI interface
Signal-to-Noise Ratio	SNR	-	93	-	dB	A-weighted, typical value
Total Harmonic Distortion	THD+N	-	-100	-	dB	A-weighted, typical value
Power Consumption	IDD	-	12	-	mA	Active mode, typical value
Shutdown Current	ISD	-	1	-	μA	Shutdown mode, typical value
Operating Temperature	Toper	-40	-	85	°C	-
Storage Temperature	Tstg	-65	-	150	°C	-

Instructions for Using AD1866RZ

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the specified range of 2.7V to 5.5V.
   • Use a stable power source to avoid noise and instability.

2. Analog Input:

   • Connect the analog input signals to the differential input pins (VIN+ and VIN-).
   • Ensure the input voltage does not exceed the supply voltage (VDD).

3. Output Data Rate Configuration:

   • Configure the output data rate (fODR) using the SPI interface.
   • Valid data rates include 4kHz, 8kHz, 16kHz, 32kHz, 48kHz, 96kHz, and 192kHz.

4. Signal-to-Noise Ratio (SNR):

   • The SNR is typically 93dB, which is suitable for high-fidelity audio applications.
   • Ensure that the analog input signal is clean to maintain this performance.

5. Total Harmonic Distortion (THD+N):

   • The THD+N is typically -100dB, indicating low distortion and noise.
   • Use high-quality components and proper PCB layout to minimize additional noise.

6. Power Management:

   • In active mode, the device consumes approximately 12mA.
   • To reduce power consumption, use the shutdown mode, which reduces current to about 1μA.

7. Temperature Considerations:

   • Operate the device within the temperature range of -40°C to 85°C for optimal performance.
   • Store the device between -65°C and 150°C.

8. SPI Interface:

   • Use the SPI interface to configure the device settings, including the output data rate and other operational parameters.
   • Refer to the datasheet for specific SPI command codes and timing diagrams.

9. PCB Layout:

   • Place decoupling capacitors close to the power supply pins to reduce noise.
   • Use a ground plane to minimize interference and improve signal integrity.

10. Handling:

    • Handle the device with care to avoid static damage.
    • Follow ESD (Electrostatic Discharge) precautions when handling the device.

For detailed specifications and additional information, refer to the AD1866RZ datasheet provided by Analog Devices.

(For reference only)