Details

---

BUY MAX3110ECWI https://www.utsource.net/itm/p/802808.html
SPI/MICROWIRE-Compatible UART and 【15kV ESDProtected RS-232 Transceivers with Internal Capacitors

Parameter	Symbol	Min	Typical	Max	Unit
Supply Voltage	VCC	2.7	-	5.5	V
Operating Temperature	Toper	-40	-	85	°C
Storage Temperature	Tstg	-65	-	150	°C
Input Voltage Range	VIN	0	-	VCC	V
Output Current	IOUT	-	1.5	3	mA
Quiescent Current	IQ	-	300	-	μA
Data Rate	fD	-	115.2	-	kbps
Communication Interface	IF	-	SPI	-	-
Package Type	PKG	-	28-pin	-	TSSOP

Instructions for Using the MAX3110ECWI

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the range of 2.7V to 5.5V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Temperature Considerations:

   • The device operates within a temperature range of -40°C to 85°C.
   • Store the device between -65°C and 150°C.

3. Input Voltage:

   • The input voltage (VIN) should be between 0V and VCC to avoid damage.

4. Output Current:

   • The typical output current (IOUT) is 1.5mA, with a maximum of 3mA. Ensure the load does not exceed this limit.

5. Quiescent Current:

   • The quiescent current (IQ) is typically 300μA. This value helps in power budgeting for low-power applications.

6. Data Rate:

   • The typical data rate (fD) is 115.2kbps. Adjust the communication settings accordingly.

7. Communication Interface:

   • The MAX3110ECWI supports SPI communication. Configure the SPI settings as per your application requirements.

8. Package Information:

   • The device comes in a 28-pin TSSOP package. Refer to the mechanical drawings in the datasheet for pin layout and dimensions.

9. Handling and Storage:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage.
   • Store the device in a dry and cool environment to prevent moisture damage.

10. Application Notes:

    • For detailed application notes and specific use cases, refer to the official Maxim Integrated datasheet and application notes.

11. Troubleshooting:

    • If the device does not function as expected, check the power supply, ground connections, and communication lines for any issues.
    • Use a multimeter to verify the supply voltage and output currents.
    • Ensure the SPI communication settings are correctly configured.

(For reference only)