Details

---

BUY M95160-WMN6TP https://www.utsource.net/itm/p/821126.html
16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock

Parameter	Description	Value
Device Type	Serial EEPROM	16Kbit
Package	WLCSP (Wafer-Level Chip Scale Package)	6 Bump
Operating Voltage (V)	Supply Voltage Range	1.7V to 3.6V
Operating Temperature	Industrial Temperature Range	-40°C to +85°C
Interface	I2C (Two-Wire Serial Interface)	Up to 1 MHz
Memory Organization	Memory Size and Structure	2048 x 8 bits
Write Cycle Time	Time to Complete a Write Operation	5 ms (max)
Data Retention	Minimum Data Retention Time	100 years at 25°C
Endurance	Number of Write/Erase Cycles per Byte	1,000,000 cycles (min)
Standby Current	Current Consumption in Standby Mode	1 μA (max)
Active Current	Current Consumption During Read/Write Operations	3 mA (max)
SMBus Compatibility	Compatibility with SMBus Protocol	Yes
Write Protection	Software Write Protect Feature	Yes
Package Dimensions	Physical Size of the Package	0.8 mm x 0.8 mm x 0.25 mm

Instructions for Use:

1. Power Supply:

   • Connect the VCC pin to a power supply within the operating voltage range (1.7V to 3.6V).
   • Connect the GND pin to ground.

2. I2C Interface:

   • Connect the SDA (Serial Data) and SCL (Serial Clock) pins to the corresponding lines on your I2C bus.
   • Ensure that pull-up resistors are used on the SDA and SCL lines, typically between 1.8 kΩ and 10 kΩ, depending on the bus length and speed.

3. Address Configuration:

   • The device has a fixed I2C address. Refer to the datasheet for the specific address.

4. Read Operation:

   • Start a read operation by sending a start condition, followed by the device address with the read bit set.
   • The device will respond with an acknowledgment.
   • Read the desired number of bytes from the device.
   • Send a stop condition to end the read operation.

5. Write Operation:

   • Start a write operation by sending a start condition, followed by the device address with the write bit set.
   • The device will respond with an acknowledgment.
   • Send the memory address where you want to write data.
   • Send the data byte(s) to be written.
   • The device will acknowledge each byte.
   • Send a stop condition to end the write operation.

6. Write Protection:

   • Use the software write protect feature to prevent accidental writes to the memory. This is typically done by writing a specific value to a control register.

7. Data Retention and Endurance:

   • Ensure that the device is operated within the specified temperature range to maintain data retention and endurance.
   • Avoid excessive write cycles to any single memory location to prevent wear-out.

8. Handling Precautions:

   • Handle the device with care to avoid static damage.
   • Follow proper soldering and handling procedures to ensure reliable performance.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)