Details

---

BUY EPF10K20TC144-4 https://www.utsource.net/itm/p/1101842.html
IC FLEX 10K FPGA 20K 144-TQFP

Parameter	Description	Value
Device Type	Type of device	CPLD (Complex Programmable Logic Device)
Family	Family of the device	FLEX 10K
Part Number	Specific part number	EPF10K20TC144-4
Package	Package type	TQFP (Thin Quad Flat Package)
Pins	Number of pins	144
Speed Grade	Speed grade of the device	-4 (fastest for this family)
Logic Cells	Number of logic cells	20,000
I/O Pins	Number of I/O pins	132
Internal Memory (bits)	Internal memory size	576 bits
Max. Operating Frequency	Maximum operating frequency	181 MHz
Supply Voltage (Vcc)	Supply voltage range	3.3V ± 5%
Standby Current	Current consumption in standby mode	50 μA
Active Power	Power consumption in active mode	1.5 W (typical)
Temperature Range	Operating temperature range	-40°C to +85°C
Configuration Method	Method for configuring the device	JTAG, AS (Active Serial), PS (Passive Serial)
Programming Voltage	Voltage required for programming	3.3V
Programming Time	Typical time required for programming	20 ms (for full configuration)
ESD Protection	Electrostatic discharge protection	2000 V (HBM)
RoHS Compliance	Compliance with Restriction of Hazardous Substances Directive	Yes

Instructions for Use

1. Power Supply:

   • Ensure that the supply voltage (Vcc) is within the specified range of 3.3V ± 5%.
   • Connect the ground (GND) pin to a stable ground reference.

2. Configuration:

   • Use one of the supported configuration methods: JTAG, Active Serial (AS), or Passive Serial (PS).
   • For JTAG, connect the TDI, TDO, TCK, and TMS pins to the JTAG interface.
   • For AS, connect the AS_DATA, AS_CLK, and AS_DCLK pins to the configuration source.
   • For PS, connect the PS_DATA and PS_CLK pins to the configuration source.

3. Programming:

   • Use a compatible programmer or software to load the configuration file.
   • Ensure the programming voltage is set to 3.3V.
   • The typical programming time is 20 ms for a full configuration.

4. Operating Conditions:

   • Operate the device within the specified temperature range of -40°C to +85°C.
   • Avoid exceeding the maximum operating frequency of 181 MHz to prevent performance issues.

5. Handling:

   • Handle the device with care to avoid ESD damage.
   • Store the device in an ESD-protected environment when not in use.

6. Testing:

   • After programming, verify the functionality of the device using appropriate test vectors.
   • Monitor power consumption and ensure it does not exceed the specified active power of 1.5 W (typical).

7. Documentation:

   • Refer to the datasheet and user manual for detailed information on pinouts, timing diagrams, and advanced features.

(For reference only)