Details

---

BUY CD4093BM https://www.utsource.net/itm/p/1176054.html
2-Input Quad Nand Schmitt Trigger2

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	3	10	18	V
Input High Voltage	VIH	IIH = 10 渭A	2VCC/3	-	VCC - 1.5	V
Input Low Voltage	VIL	IIL = -1 渭A	0	-	VCC/3	V
Output High Voltage	VOH	IOH = -0.4 mA	VCC - 2.5	-	VCC - 0.5	V
Output Low Voltage	VOL	IOL = 8 mA	0	-	0.4	V
Propagation Delay Time	tpd	VCC = 5 V, f = 1 MHz	-	30	-	ns
Power Dissipation	PD	Per Package	-	-	100	mW
Operating Temperature	TA	-	-40	-	85	掳C
Storage Temperature	TSTG	-	-65	-	150	掳C

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the specified range (3 to 18 V).
   • Connect the ground (GND) pin to a stable reference ground.

2. Input Signals:

   • Apply input signals that meet the input high (V_IH) and input low (V_IL) voltage levels.
   • Avoid exceeding the maximum input voltage, which should not exceed V_CC.

3. Output Signals:

   • The output high (V_OH) and output low (V_OL) voltages should be within the specified limits.
   • Ensure the output current does not exceed the maximum ratings to avoid damage to the device.

4. Propagation Delay:

   • The propagation delay time (t_pd) is typically 30 ns at V_CC = 5 V and f = 1 MHz. This value can vary with different supply voltages and frequencies.

5. Temperature Considerations:

   • Operate the device within the specified operating temperature range (-40 to 85 掳C).
   • Store the device within the storage temperature range (-65 to 150 掳C).

6. Handling:

   • Handle the device with care to avoid static discharge, which can damage the internal components.
   • Follow proper soldering techniques to ensure reliable connections and prevent thermal stress.

7. Testing:

   • Before integrating the CD4093BM into a circuit, test it using a known good setup to verify its functionality.
   • Use a multimeter or oscilloscope to check the input and output voltages and waveforms.

8. Layout and PCB Design:

   • Keep the power and ground lines short and wide to minimize noise and improve stability.
   • Place decoupling capacitors close to the V_CC and GND pins to filter out any supply noise.

By following these guidelines, you can ensure optimal performance and reliability of the CD4093BM in your electronic circuits.

(For reference only)