Details

---

BUY CD4024 https://www.utsource.net/itm/p/1233877.html
7-Stage Ripple Carry Binary Counter

Below is the parameter table and instructions for the CD4024 CMOS 7-Stage Ripple Counter.

CD4024 Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VDD	3.0	-	15.0	V	-
Input Low Voltage	VIL	0.0	-	0.8	V	VDD = 5V
Input High Voltage	VIH	2.0	-	VDD	V	VDD = 5V
Output Low Voltage	VOL	0.0	0.1	0.4	V	IOL = 1.0mA, VDD = 5V
Output High Voltage	VOH	2.4	2.7	VDD - 0.1	V	IOH = -0.4mA, VDD = 5V
Input Leakage Current	IIL	-1.0	-	1.0	渭A	VDD = 5V
Output Leakage Current	IOL	-50	-	50	nA	VDD = 5V
Propagation Delay Time	tpd	-	40	-	ns	VDD = 5V, f = 1MHz
Power Consumption	Ptot	-	-	10	mW	VDD = 5V, f = 1MHz

Instructions for Using CD4024

1. Power Supply:

   • Connect the V_DD pin to the positive supply voltage (3.0V to 15.0V).
   • Connect the GND pin to the ground.

2. Input Signal:

   • Apply the clock signal to the CP (Clock Pulse) input.
   • The clock signal should be within the specified input voltage levels (V_IL and V_IH).

3. Output Signals:

   • The CD4024 has seven output stages (Q0 to Q6), which provide binary count outputs.
   • Each stage divides the frequency of the previous stage by 2, starting from the CP input.

4. Reset Function:

   • The MR (Master Reset) pin can be used to reset the counter to zero.
   • Apply a low (0V) signal to the MR pin to reset the counter.

5. Propagation Delay:

   • The propagation delay time (t_pd) is the time it takes for the output to change after the clock edge.
   • Ensure that the clock frequency is within the range where the propagation delay does not cause timing issues.

6. Power Consumption:

   • The power consumption of the CD4024 increases with higher supply voltages and clock frequencies.
   • Ensure that the power supply can handle the maximum power consumption specified.

7. Operating Temperature:

   • The CD4024 can operate over a wide temperature range, typically from -55掳C to +125掳C.

8. Handling Precautions:

   • The CD4024 is a static-sensitive device. Use proper ESD (Electrostatic Discharge) protection when handling the component.
   • Avoid exposing the device to excessive heat or moisture.

By following these instructions, you can effectively use the CD4024 CMOS 7-Stage Ripple Counter in your circuits.

(For reference only)