Details

---

BUY TMS320C6713BZDP225 https://www.utsource.net/itm/p/1324580.html
Floating-Point Digital Signal Processors 272-BGA

Parameter	Description	Value
Device Type	Digital Signal Processor (DSP)	-
Part Number	TMS320C6713BZDP225	-
Core	C67x+	-
Clock Frequency	Maximum Operating Frequency	225 MHz
Voltage Supply (Vcc)	Core Supply Voltage	1.8 V
Voltage Supply (Vcc)	I/O Supply Voltage	3.3 V / 1.8 V
Power Consumption	Typical Power Consumption	1.5 W (at 225 MHz)
Memory	On-chip RAM	1 MB (64 KB + 960 KB)
Memory	On-chip ROM	256 KB
Memory	External Memory Interface (EMIF)	Supports up to 1 GB
Interfaces	JTAG	Yes
Interfaces	HPI (Host Port Interface)	16-bit or 8-bit
Interfaces	McBSP (Multichannel Buffered Serial Port)	2
Interfaces	SPI (Serial Peripheral Interface)	1
Interfaces	I2C (Inter-Integrated Circuit)	1
Interfaces	GPIO (General Purpose Input/Output)	64
Packaging	Package Type	BGA (Ball Grid Array)
Pin Count	Total Pins	676
Operating Temperature Range	Commercial	0°C to 70°C
Operating Temperature Range	Industrial	-40°C to 85°C
Storage Temperature Range	-65°C to 150°C
ESD Protection	Human Body Model (HBM)	±2 kV
ESD Protection	Machine Model (MM)	±200 V
ESD Protection	Charged Device Model (CDM)	±1 kV

Instructions for Using TMS320C6713BZDP225

1. Power Supply Configuration:

   • Ensure that the core supply voltage (Vcc) is set to 1.8 V.
   • The I/O supply voltage can be set to either 3.3 V or 1.8 V depending on the peripheral requirements.

2. Clock Configuration:

   • Set the clock frequency to 225 MHz for optimal performance. Use an external crystal oscillator or PLL (Phase-Locked Loop) to generate the required clock signal.

3. Memory Initialization:

   • Initialize the on-chip RAM and ROM according to your application needs. The 1 MB of on-chip RAM can be divided into 64 KB and 960 KB segments.
   • Configure the External Memory Interface (EMIF) to access up to 1 GB of external memory if needed.

4. Interface Configuration:

   • Configure the JTAG interface for debugging and programming.
   • Set up the HPI (Host Port Interface) for communication with a host system, choosing between 16-bit or 8-bit mode.
   • Initialize the McBSPs for serial data communication.
   • Configure the SPI and I2C interfaces for connecting to peripheral devices.
   • Assign GPIO pins for general-purpose input/output functions as required by your application.

5. Thermal Management:

   • Ensure adequate cooling to keep the operating temperature within the specified range (0°C to 70°C for commercial grade, -40°C to 85°C for industrial grade).
   • Use heat sinks or other cooling solutions if necessary to maintain thermal stability.

6. ESD Protection:

   • Handle the device with care to avoid electrostatic discharge (ESD). Use proper ESD protection measures such as grounded wrist straps and ESD-safe workstations.
   • Follow the ESD protection ratings to ensure the device is not damaged during handling and installation.

7. Programming and Debugging:

   • Use a supported development environment (e.g., Code Composer Studio) to write and debug your code.
   • Utilize the JTAG interface for in-circuit debugging and programming.
   • Test the device thoroughly to ensure it meets the performance and functional requirements of your application.

(For reference only)