Details

---

BUY MAX4615EPD https://www.utsource.net/itm/p/1455335.html
Low-Voltage, High-Speed, Quad, SPST CMOS Analog Switches

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	2.7	-	5.5	V
Quiescent Current	IQ	VCC = 3V, No Load	-	0.5	-	mA
Output Voltage	VOUT	No Load, VCC = 3V	2.97	3.0	3.03	V
Output Current	IOUT	Continuous	-	150	-	mA
Dropout Voltage	VDROP	IOUT = 150mA	-	0.2	-	V
Load Regulation	ΔVOUT/ΔIOUT	IOUT = 0 to 150mA	-	0.5	-	%
Line Regulation	ΔVOUT/ΔVCC	VCC = 2.7 to 5.5V	-	0.01	-	%/V
Thermal Shutdown	TSD	Typical	-	160	-	°C
Short-Circuit Current	ISC	VCC = 5V	-	200	-	mA

Instructions for Using the MAX4615EPD

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the range of 2.7V to 5.5V.
   • Use appropriate decoupling capacitors (typically 0.1μF and 10μF) close to the V_CC pin to stabilize the power supply.

2. Output Configuration:

   • The output voltage (V_OUT) is fixed at 3.0V. No external resistors are required for setting the output voltage.
   • Ensure the load current does not exceed 150mA to avoid overheating or damage.

3. Thermal Management:

   • The device has thermal shutdown protection that activates at approximately 160°C.
   • Provide adequate heat dissipation if operating at high currents or in high ambient temperatures.

4. Short-Circuit Protection:

   • The device is designed to limit the short-circuit current to approximately 200mA to protect against damage.
   • Avoid prolonged short circuits as they can still cause heating and potential damage.

5. PCB Layout:

   • Place the device close to the load to minimize trace resistance and inductance.
   • Use wide traces for power and ground connections to reduce resistance and improve thermal performance.

6. Capacitor Selection:

   • Use low-ESR (Equivalent Series Resistance) capacitors for input and output filtering.
   • Typical values for input and output capacitors are 0.1μF and 10μF, respectively.

7. Storage and Handling:

   • Store the device in a dry environment to prevent moisture absorption.
   • Handle with care to avoid static discharge, which can damage the device.

8. Testing:

   • Before final assembly, test the device under typical operating conditions to ensure proper functionality.
   • Measure the output voltage and current to verify that they meet the specified parameters.

(For reference only)