Details

---

BUY FAN73711 https://www.utsource.net/itm/p/1905210.html

Parameter	Symbol	Test Conditions	Min	Typical	Max	Unit
Supply Voltage	Vcc	-	4.5	-	20	V
Operating Junction Temperature	Tj	-	-40	-	150	°C
Gate Charge	Qg	Vgs = 15V, Id = 10A	-	36	-	nC
Input Capacitance	Cin	Vgs = 12V	-	1400	-	pF
Output Capacitance	Cout	Vds = 12V	-	380	-	pF
Turn-On Delay Time	td(on)	Vgs = 12V, Id = 10A	-	28	-	ns
Turn-Off Delay Time	td(off)	Vgs = 12V, Id = 10A	-	25	-	ns
Rise Time	tr	Vgs = 12V, Id = 10A	-	20	-	ns
Fall Time	tf	Vgs = 12V, Id = 10A	-	20	-	ns
Continuous Drain Current	Id	Vds = 100V, Tc = 25°C	-	10	-	A
Peak Drain Current	Idp	Vds = 100V, Tc = 25°C	-	20	-	A
Drain-Source Breakdown Voltage	BVdss	Id = 250μA, Tj = 25°C	-	100	-	V

Instructions for Use:

1. Supply Voltage (Vcc):

   • Ensure the supply voltage is within the range of 4.5V to 20V to avoid damage to the device.

2. Operating Junction Temperature (Tj):

   • The device can operate over a temperature range from -40°C to 150°C. Ensure proper heat dissipation to maintain the junction temperature within this range.

3. Gate Charge (Qg):

   • The gate charge is 36 nC at Vgs = 15V and Id = 10A. This parameter is crucial for determining the drive requirements.

4. Input Capacitance (Cin):

   • The input capacitance is 1400 pF at Vgs = 12V. This affects the switching speed and drive circuit design.

5. Output Capacitance (Cout):

   • The output capacitance is 380 pF at Vds = 12V. This parameter influences the turn-off characteristics.

6. Turn-On and Turn-Off Delay Times (td(on), td(off)):

   • The turn-on delay time is 28 ns and the turn-off delay time is 25 ns at Vgs = 12V and Id = 10A. These times help in designing the timing of the drive signals.

7. Rise and Fall Times (tr, tf):

   • The rise time is 20 ns and the fall time is 20 ns at Vgs = 12V and Id = 10A. These parameters are important for minimizing switching losses.

8. Continuous Drain Current (Id):

   • The continuous drain current is 10A at Vds = 100V and Tc = 25°C. Ensure that the load does not exceed this current to prevent overheating.

9. Peak Drain Current (Idp):

   • The peak drain current is 20A at Vds = 100V and Tc = 25°C. This is the maximum current the device can handle for short durations.

10. Drain-Source Breakdown Voltage (BVdss):

    • The drain-source breakdown voltage is 100V at Id = 250μA and Tj = 25°C. Do not exceed this voltage to avoid damaging the device.

Additional Notes:

• Always refer to the datasheet for more detailed information and specific application notes.
• Proper PCB layout and thermal management are essential for reliable operation.
• Use appropriate decoupling capacitors to ensure stable power supply and reduce noise.

(For reference only)