Details

---

BUY AT29C010A-12TC https://www.utsource.net/itm/p/4140669.html
1 Megabit 128K x 8 5-volt Only CMOS Flash Memory

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	4.5	5.0	5.5	V
Standby Current	ICC(STBY)	VCC = 5V, CS = VCC, OE = GND	-	0.1	1	μA
Active Current	ICC(ACTIVE)	VCC = 5V, CS = GND, OE = GND	10	25	50	mA
Write Current	ICC(WRITE)	VCC = 5V, CS = GND, OE = GND, WE = GND	30	60	90	mA
Access Time	tAA	VCC = 5V, TA = 25°C	120	-	-	ns
Write Cycle Time	tWC	VCC = 5V, TA = 25°C	8	-	-	ms
Write Enable Setup Time	tWS	VCC = 5V, TA = 25°C	0	-	10	ns
Write Enable Hold Time	tWH	VCC = 5V, TA = 25°C	0	-	10	ns
Output High Level	VOH	IO = -0.4mA, VCC = 5V	2.4	-	VCC-0.1	V
Output Low Level	VOL	IO = 1.6mA, VCC = 5V	0	-	0.4	V
Input High Level	VIH	VCC = 5V	2.0	-	VCC	V
Input Low Level	VIL	VCC = 5V	0	-	0.8	V

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the specified range of 4.5V to 5.5V.

2. Standby Mode:

   • To minimize power consumption, set the Chip Select (CS) pin to V_CC and the Output Enable (OE) pin to GND.

3. Active Mode:

   • For normal operation, set the Chip Select (CS) pin to GND and the Output Enable (OE) pin to GND.

4. Write Operation:

   • To write data, set the Chip Select (CS) pin to GND, the Output Enable (OE) pin to GND, and the Write Enable (WE) pin to GND. The write cycle time (t_WC) must be at least 8 milliseconds.

5. Timing Considerations:

   • Ensure that the access time (t_AA) is at least 120 nanoseconds.
   • The Write Enable (WE) signal must meet the setup time (t_WS) and hold time (t_WH) requirements of 0 to 10 nanoseconds.

6. Signal Levels:

   • Verify that the input and output signal levels are within the specified ranges to ensure proper operation.

7. Storage and Handling:

   • Store the device in a dry environment and handle with care to avoid damage from electrostatic discharge (ESD).

8. Programming:

   • Use appropriate programming algorithms and software to write data to the device. Refer to the device datasheet for specific programming sequences and protocols.

For detailed programming and application notes, refer to the official datasheet and application notes provided by the manufacturer.

(For reference only)