Details

---

BUY MT48LC8M16A2P-75IT:G https://www.utsource.net/itm/p/4907112.html

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Supply Voltage	VCC	2.5		3.6	V
Standby Current	ICC		0.2	1	μA
Active Current (Read/Write)	ICC		30	50	mA
Access Time	tAA		70		ns
Data Output Hold Time	tOH		5		ns
Data Input Setup Time	tIS		5		ns
Chip Enable Setup Time	tCES		5		ns
Chip Enable Hold Time	tCEH		5		ns
Output Enable Setup Time	tOES		5		ns
Output Enable Hold Time	tOEH		5		ns
Write Enable Setup Time	tWES		5		ns
Write Enable Hold Time	tWEH		5		ns
Address Latch Time	tAL		5		ns
Address Valid to WE Low	tAWL		5		ns
Write Cycle Time	tWC		70		ns
Read Cycle Time	tRC		70		ns
Power-down Mode Entry Time	tPD		5		ns
Power-down Mode Exit Time	tPX		5		ns

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the specified range of 2.5V to 3.6V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Signal Levels:

   • All input signals should be TTL/CMOS compatible.
   • Output signals are valid when the chip enable (CE) and output enable (OE) pins are active low.

3. Timing Considerations:

   • Respect all timing parameters listed in the table to ensure reliable operation.
   • Use appropriate pull-up or pull-down resistors for unused inputs to prevent floating states.

4. Operation Modes:

   • Read Operation:
     • Set CE and OE low.
     • Provide the address on the address lines.
     • Data will be available on the data lines after the access time (tAA).
   • Write Operation:
     • Set CE and WE low.
     • Provide the address on the address lines.
     • Provide the data on the data lines.
     • Maintain the write cycle time (tWC).

5. Power Management:

   • To enter power-down mode, set CE high.
   • To exit power-down mode, set CE low and wait for the power-down exit time (tPX).

6. Storage and Handling:

   • Store the device in a dry, static-free environment.
   • Handle with care to avoid damage to the pins and internal components.

7. Environmental Conditions:

   • Operating temperature range: -40°C to +85°C.
   • Storage temperature range: -65°C to +150°C.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)