Details

---

BUY STDVE103ABTY https://www.utsource.net/itm/p/5220983.html
IC INTERFACE SPECIALIZED 64TQFP

Parameter	Symbol	Min	Typical	Max	Unit
Continuous Collector Current	IC	-	3.0	-	A
Peak Collector Current	ICM	-	6.0	-	A (t=1ms)
Collector-Emitter Voltage	VCEO	-	100	-	V
Emitter-Base Voltage	VEBO	-	5.0	-	V
Storage Temperature Range	Tstg	-65	-	150	°C
Operating Junction Temperature	TJ	-55	-	150	°C

Instructions for Use:

1. Mounting:

   • Ensure proper heat dissipation by mounting the device on a heatsink if operating near maximum current or voltage.
   • Use thermal compound between the device and heatsink to improve thermal conductivity.

2. Wiring:

   • Connect the collector (C) to the load and power supply.
   • Connect the emitter (E) to ground.
   • Connect the base (B) to the control circuit.

3. Protection:

   • Use a fast-acting fuse in series with the power supply to protect against short circuits.
   • Consider adding a snubber circuit (resistor and capacitor in series) across the collector and emitter to suppress voltage transients.

4. Operating Conditions:

   • Do not exceed the maximum ratings listed in the table.
   • Ensure the junction temperature remains within the specified range to avoid thermal damage.

5. Storage:

   • Store the device in a dry, cool place away from direct sunlight and corrosive environments.
   • Handle with care to avoid mechanical damage.

6. Testing:

   • Before installation, test the device using a multimeter to ensure it is functioning correctly.
   • Check for continuity between the base and emitter, and the collector and emitter, while ensuring there is no continuity between the collector and base.

(For reference only)