MCF51AC256BCLKE

MCF51AC256BCLKE

Category: IC Chips

Specifications
SKU
5987597
Details

BUY MCF51AC256BCLKE https://www.utsource.net/itm/p/5987597.html
ColdFire Microcontroller
Parameter Description Value
Device Type 32-bit Microcontroller
Family ColdFire V1
Package LQFP (144-Pin)
Operating Voltage (Vcc) Supply Voltage Range 3.0 V to 3.6 V
Operating Temperature Temperature Range -40°C to +85°C
Clock Frequency Maximum CPU Clock Frequency 40 MHz
Flash Memory On-chip Flash Memory Size 256 KB
RAM On-chip RAM Size 16 KB
Data EEPROM On-chip Data EEPROM Size 4 KB
ADC Analog-to-Digital Converter Channels 8 channels
DAC Digital-to-Analog Converter Channels 2 channels
Timers Number of Timers 4
PWM Pulse Width Modulation Channels 4
Serial Interfaces UART, SPI, I2C 2 UARTs, 1 SPI, 1 I2C
Watchdog Timer Integrated Watchdog Timer Yes
Brown-out Detector Integrated Brown-out Detector Yes
Power Management Low Power Modes Sleep, Stop, Wait
Interrupts Number of Interrupt Vectors 64
Pin Count Total Number of Pins 144
Package Dimensions Package Size 20 mm x 20 mm

Instructions for Use

  1. Power Supply:

    • Ensure the supply voltage (Vcc) is within the range of 3.0 V to 3.6 V.
    • Connect the power supply to the Vcc and GND pins as specified in the datasheet.
  2. Clock Configuration:

    • The device supports an external crystal or oscillator for clock generation.
    • Configure the clock source and frequency using the internal clock control registers.
  3. Memory Initialization:

    • Initialize the flash memory and RAM by writing appropriate values to the memory control registers.
    • Use the on-chip bootloader for initial programming if required.
  4. Peripheral Configuration:

    • Configure the ADC, DAC, timers, PWM, and serial interfaces using the respective peripheral control registers.
    • Refer to the datasheet for specific register settings and configurations.
  5. Interrupt Handling:

    • Set up interrupt vectors and enable interrupts for the desired peripherals.
    • Write interrupt service routines (ISRs) to handle interrupt events.
  6. Low Power Modes:

    • Use the sleep, stop, and wait modes to reduce power consumption.
    • Configure the power management settings to enter and exit low power modes as needed.
  7. Programming and Debugging:

    • Use an in-circuit debugger or programmer to load and debug code.
    • Refer to the development tools and software provided by the manufacturer for detailed instructions.
  8. Environmental Considerations:

    • Ensure the operating temperature is within the range of -40°C to +85°C.
    • Protect the device from excessive humidity and static electricity.

For more detailed information, refer to the datasheet and application notes provided by the manufacturer.

(For reference only)

View more about MCF51AC256BCLKE on main site