Details

---

BUY SKM25GD125D https://www.utsource.net/itm/p/6369899.html

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Rated Voltage (VDS)	VDS	-	1200	-	V
Continuous Drain Current	ID	-	25	-	A	@ Tc = 25°C
Pulse Drain Current	ICM	-	100	-	A	tp = 10 ms, duty cycle = 1%
Gate-Source Voltage	VGS	-15	0	20	V
Gate Charge	QG	-	380	-	nC
Total Switching Energy	ETS	-	167	-	μJ	@ VGE = 15 V, VDS = 800 V, ID = 25 A
Input Capacitance	Ciss	-	4290	-	pF	@ VDS = 600 V, f = 1 MHz
Output Capacitance	Coss	-	320	-	pF	@ VDS = 600 V, f = 1 MHz
Reverse Transfer Capacitance	Crss	-	3970	-	pF	@ VDS = 600 V, f = 1 MHz
On-State Resistance	RDS(on)	-	1.7	-	Ω	@ VGS = 15 V, ID = 25 A, Tc = 25°C
Junction Temperature	TJ	-55	-	175	°C
Storage Temperature	TSTG	-55	-	150	°C

Instructions for Use:

1. Handling Precautions:

   • Avoid exposing the device to excessive mechanical stress.
   • Handle with care to prevent damage to the pins and the body of the device.

2. Thermal Management:

   • Ensure adequate heat sinking to maintain the junction temperature within the specified limits.
   • Use thermal paste or other thermal management materials to improve heat dissipation.

3. Electrical Connections:

   • Ensure that all connections are secure and free from oxidation or corrosion.
   • Use appropriate wire gauges to handle the current levels.

4. Gate Drive:

   • Provide a clean and stable gate drive signal to avoid spurious turn-on or turn-off.
   • Use a gate resistor to control the switching speed and reduce EMI.

5. Overvoltage Protection:

   • Implement overvoltage protection circuits to safeguard against transient voltage spikes.
   • Consider using snubber circuits to dampen ringing and reduce voltage overshoots.

6. Storage and Transportation:

   • Store the device in a dry, cool place away from direct sunlight.
   • Follow ESD (Electrostatic Discharge) precautions during handling and installation.

7. Testing:

   • Perform initial testing under controlled conditions to ensure proper operation.
   • Monitor temperature and electrical parameters during operation to ensure they remain within safe limits.

(For reference only)