Details

---

BUY MAX1406EPE+ https://www.utsource.net/itm/p/7531598.html
3/3 Transceiver Full RS232 16-PDIP

Parameter	Symbol	Conditions	Min	Typical	Max	Unit
Supply Voltage	VDD	Operating	4.5	-	5.5	V
Input Voltage Range	VIN		0	-	VDD	V
Output Voltage Range	VOUT		0	-	VDD	V
Input Bias Current	IB	VIN = 0V	-	10	-	nA
Input Offset Voltage	VOS	VIN = 0V	-	2.5	-	mV
Input Resistance	RIN		-	10	-	MΩ
Output Short-Circuit		Continuous	-	-	-	-
Operating Temperature	Toper		-40	-	85	°C
Storage Temperature	Tstg		-65	-	150	°C

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 4.5V to 5.5V.
   • Connect the power supply to the VDD pin and ground to the GND pin.

2. Input Connection:

   • Connect the analog input signal to the VIN pin.
   • The input voltage should be within the range of 0V to VDD.

3. Output Connection:

   • The output signal will be available on the VOUT pin.
   • The output voltage will be within the range of 0V to VDD.

4. Bias Current:

   • The input bias current is typically 10nA at VIN = 0V. Ensure that the source impedance is compatible with this bias current to avoid significant voltage drops.

5. Offset Voltage:

   • The input offset voltage is typically 2.5mV at VIN = 0V. This should be considered when designing the circuit to minimize errors.

6. Input Resistance:

   • The input resistance is typically 10MΩ. Ensure that the source impedance is much lower than this value to avoid loading effects.

7. Temperature Considerations:

   • The device is designed to operate within the temperature range of -40°C to 85°C.
   • Store the device within the temperature range of -65°C to 150°C.

8. Short-Circuit Protection:

   • The output is protected against continuous short-circuits. However, it is recommended to avoid short-circuits to ensure reliable operation.

9. Handling:

   • Handle the device with care to avoid static damage. Use proper ESD protection practices during handling and installation.

10. Layout Considerations:

    • Keep the PCB layout compact to minimize noise pickup.
    • Use bypass capacitors close to the VDD and GND pins to filter out any power supply noise.

(For reference only)