Details
BUY M7 https://www.utsource.net/itm/p/8647480.html
| Parameter | Value | Description |
|---|---|---|
| Part Number | M7 | Schottky Diode |
| Maximum Reverse Voltage (VR) | 20V | Maximum voltage that can be applied in reverse direction without breakdown |
| Forward Voltage (VF) @ 1A | 0.45V | Voltage drop across the diode when conducting forward current at 1A |
| Peak Forward Current (IFSM) | 30A | Maximum instantaneous forward current the diode can handle |
| Average Rectified Output Current (IO) | 1A | Continuous average rectified output current the diode can handle |
| Reverse Recovery Time (trr) | 35ns | Time it takes for the diode to switch from conducting to non-conducting state |
| Junction Operating Temperature (TJ) | -65掳C to +150掳C | Range of temperatures over which the diode can operate safely |
| Storage Temperature (TSTG) | -65掳C to +150掳C | Range of temperatures over which the diode can be stored safely |
| Thermal Resistance (R胃JA) | 40掳C/W | Thermal resistance from the junction to the ambient environment |
| Package Type | DO-204AD | Physical package type |
Instructions for Use:
Mounting:
- Ensure proper heat sinking if operating near maximum current or power dissipation.
- Avoid mechanical stress on the leads during soldering and handling.
Soldering:
- Use a temperature-controlled soldering iron with a maximum tip temperature of 300掳C.
- Soldering time should not exceed 10 seconds per joint.
- Allow the diode to cool down to room temperature before applying any electrical stress.
Electrical Connections:
- Connect the anode (A) to the positive side of the circuit and the cathode (K) to the negative side.
- Ensure the reverse voltage does not exceed the maximum rated value of 20V to prevent breakdown.
Storage:
- Store the diode in a dry, cool place within the specified storage temperature range.
- Handle with care to avoid damage to the leads and body.
Testing:
- Use a multimeter to check for continuity between the anode and cathode. The diode should show low resistance in the forward direction and high resistance in the reverse direction.
- For more detailed testing, refer to the datasheet for specific test conditions and procedures.
Handling:
- Use appropriate ESD (Electrostatic Discharge) protection measures to avoid damaging the diode.
- Do not touch the leads or body of the diode with bare hands; use tweezers or other tools as needed.
View more about M7 on main site