Details

---

BUY FULLY COMPATIBLE WITH NEW NOTEBOOK MEMORY 2G DDR2 800 DDR2 2G DDR2 800 2G MEMORY https://www.utsource.net/itm/p/8648323.html

Parameter	Specification
Type	DDR2 SDRAM
Capacity	2GB
Speed	PC2-6400 (DDR2-800)
Voltage	1.8V
Module Type	240-Pin DIMM
CAS Latency	CL6
ECC	Non-ECC
Unbuffered/Registered	Unbuffered
Operating Temperature	0°C to 70°C
Compatibility	Fully compatible with new notebook models supporting DDR2-800

Instructions for Installation:

1. Power Down: Ensure your notebook is completely powered off and unplugged from any power source.
2. Access Memory Slot: Open the memory compartment of your notebook, usually located on the bottom panel. Refer to your notebook’s manual for specific instructions.
3. Align Module: Align the memory module with the slot, ensuring the notch in the module matches the raised area in the slot.
4. Insert Module: Gently push the memory module into the slot at a 45-degree angle until it clicks into place. Ensure both sides are securely locked.
5. Reassemble Notebook: Close the memory compartment cover and reattach any screws or fasteners.
6. Power On: Plug in and power on your notebook. Verify that the system recognizes the new memory by checking the system properties or using a system information tool.

Notes:

• Always handle the memory module by its edges to avoid damaging the contacts.
• Ensure your notebook supports DDR2-800 before installation to avoid compatibility issues.

(For reference only)