Details

---

BUY SSM2165-1S SOP8 https://www.utsource.net/itm/p/9272544.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	-	2.7	-	5.5	V
Quiescent Current	IQ	VIN = VOUT, RL = 1kΩ	-	30	-	μA
Input Bias Current	IB	VIN = 0V	-	1	-	nA
Input Offset Voltage	VOS	-	-	2	-	mV
Small Signal Bandwidth	fBW	AV = 1, RL = 1kΩ	-	10	-	MHz
Slew Rate	SR	-	-	6	-	V/μs
Output Voltage Swing	VOSW	ILOAD = ±10mA	-	±1.5	-	V
Power Supply Rejection	PSRR	10Hz ≤ f ≤ 10kHz	-	80	-	dB
Common Mode Rejection	CMRR	-	-	80	-	dB

Instructions for Use of SSM2165-1S SOP8

1. Supply Voltage Connection:

   • Connect the supply voltage (VDD) between 2.7V and 5.5V to pin 8 (VDD) and ground (GND) to pin 4.

2. Input Configuration:

   • Connect the input signal to pins 1 (IN+) and 2 (IN-). Ensure that the input bias current is minimized by using appropriate source impedances.

3. Output Configuration:

   • Connect the load resistor or subsequent stages to pin 5 (OUT). The output can swing within ±1.5V of the supply rails under a load current of ±10mA.

4. Power Supply Decoupling:

   • Place a decoupling capacitor (typically 0.1μF) close to the power supply pins to reduce noise and improve stability.

5. Operating Temperature Range:

   • Ensure the device operates within the specified temperature range (-40°C to +85°C) to maintain performance specifications.

6. Handling Precautions:

   • Handle the SSM2165-1S SOP8 with care to avoid damage from electrostatic discharge (ESD).

7. Testing and Evaluation:

   • For accurate testing, use evaluation boards designed specifically for this device to ensure all parameters are met under typical operating conditions.

8. Layout Considerations:

   • Keep signal paths short and direct to minimize noise pickup. Ground planes should be used extensively to provide a low impedance return path for signals and power.

By following these instructions, you can ensure optimal performance and reliability of the SSM2165-1S SOP8 in your application.

(For reference only)