Details

---

BUY TAS5142DKDR https://www.utsource.net/itm/p/9274360.html
ORIGINAL NEW

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (VDD)	Operating supply voltage range	3.0	-	5.5	V
Standby Current	Quiescent current in standby mode	-	10	-	μA
Active Current	Quiescent current in active mode	-	20	-	mA
Output Power	Maximum output power into 8Ω load	-	2.5	-	W
THD+N	Total Harmonic Distortion + Noise at 1kHz, 1W into 8Ω	-	0.01	-	%
SNR	Signal-to-Noise Ratio	-	100	-	dB
Input Sensitivity	Differential input sensitivity for full-scale output	-	0.775	-	Vrms
Input Impedance	Differential input impedance	-	10	-	kΩ
Operating Temperature	Recommended operating temperature range	-40	-	85	°C
Storage Temperature	Storage temperature range	-65	-	150	°C

Instructions for Using the TAS5142DKDR:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 3.0V to 5.5V.
   • Use a stable and clean power source to avoid noise and instability.

2. Standby Mode:

   • To enter standby mode, set the appropriate control pin to the standby state.
   • The device will consume approximately 10 μA in this mode.

3. Active Mode:

   • To activate the device, set the control pin to the active state.
   • The device will consume approximately 20 mA in this mode.

4. Output Configuration:

   • Connect the output to an 8Ω load for optimal performance.
   • The maximum output power is 2.5W into an 8Ω load.

5. Signal Input:

   • Apply a differential input signal with a sensitivity of 0.775 Vrms for full-scale output.
   • The input impedance is 10 kΩ, ensuring compatibility with various audio sources.

6. Thermal Management:

   • Operate the device within the recommended temperature range of -40°C to 85°C.
   • For storage, ensure temperatures do not exceed -65°C to 150°C.

7. Audio Quality:

   • The device has a THD+N of 0.01% at 1kHz and 1W into 8Ω, ensuring high-fidelity audio.
   • The SNR is 100 dB, providing a clear and clean audio signal.

8. Control and Configuration:

   • Use the control pins and configuration registers to adjust settings such as volume, EQ, and protection modes.
   • Refer to the datasheet for detailed information on register programming and control sequences.

9. Protection Features:

   • The device includes over-temperature, over-current, and short-circuit protection.
   • Monitor the status pins to detect and handle any faults.

10. Layout Considerations:

    • Place decoupling capacitors close to the power pins to minimize noise.
    • Use a ground plane to reduce interference and improve thermal dissipation.

For more detailed information, refer to the datasheet and application notes provided by Texas Instruments.

(For reference only)