Details

---

BUY EE-SX1088 https://www.utsource.net/itm/p/9454688.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions/Notes
Operating Voltage	VCC	4.5	-	5.5	V	-
Operating Current	ICC	-	3	-	mA	Typical value at VCC = 5V
Output Type	-	-	-	-	NPN open collector	-
Maximum Load Current	IL	-	-	50	mA	Continuous
Maximum Output Voltage	VO	-	-	30	V	-
Detection Distance	S	2	3	4	mm	At VCC = 5V, Target: 1mm thick steel plate
Response Time	tR	-	1	-	ms	Turn-ON
Release Time	tF	-	1	-	ms	Turn-OFF
Ambient Temperature	TA	-40	-	85	°C	Storage and operation
Storage Temperature	TSTG	-40	-	85	°C	-
Humidity	H	-	-	95	% RH	Non-condensing

Instructions for Use:

1. Power Supply:

   • Connect the positive terminal of the power supply to the V_CC pin.
   • Connect the negative terminal of the power supply to the GND pin.
   • Ensure the operating voltage is within the specified range (4.5V to 5.5V).

2. Output Connection:

   • The output is an NPN open collector type.
   • Connect the load between the output pin (OUT) and the positive supply (V_CC).
   • A pull-up resistor is required between the output pin and V_CC. A typical value is 1kΩ to 10kΩ.

3. Mounting:

   • Mount the sensor on a stable surface to ensure consistent detection.
   • Avoid mounting in areas with high vibration or mechanical stress.

4. Target Detection:

   • The sensor is designed to detect ferrous metal targets.
   • The detection distance can vary based on the target material and thickness.
   • For optimal performance, use a 1mm thick steel plate as a reference target.

5. Environmental Considerations:

   • Operate the sensor within the specified temperature and humidity ranges.
   • Protect the sensor from condensation and direct exposure to water.

6. Response and Release Times:

   • The sensor has a typical response time of 1ms for both turn-ON and turn-OFF.
   • These times may vary slightly depending on environmental conditions and load characteristics.

7. Handling and Installation:

   • Handle the sensor with care to avoid damage to the sensitive components.
   • Follow proper ESD (Electrostatic Discharge) precautions during installation and handling.

8. Troubleshooting:

   • If the sensor does not operate correctly, check the power supply connections and ensure the load is properly connected.
   • Verify that the target is within the specified detection range and material specifications.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)