Details

---

BUY TLP620-2(GB,F) https://www.utsource.net/itm/p/9521522.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Forward Voltage	VF	-	1.2	1.5	V	IF = 20 mA
Peak Forward Current	IF(P)	-	-	1.0	A	tP = 10 ms
Continuous Forward Current	IF	-	-	0.1	A	TA = 25°C
Reverse Voltage	VR	-	-	5.0	V
Output Current	IC	0.5	1.0	1.5	mA	VCE = 3 V, IF = 5 mA
Collector-Emitter Saturation Voltage	VCE(sat)	0.1	0.2	0.3	V	IC = 10 mA, IF = 5 mA
Turn-On Time	ton	-	2.0	4.0	μs	IF = 5 mA, RL = 100 Ω
Turn-Off Time	toff	-	1.0	2.0	μs	IF = 5 mA, RL = 100 Ω
Storage Temperature	TSTG	-40	-	100	°C
Operating Temperature	TOP	-40	-	85	°C

Instructions for Use:

1. Mounting:

   • Ensure proper heat dissipation when mounting the TLP620-2(GB,F). Use a heatsink if necessary.
   • Avoid mechanical stress on the leads during soldering.

2. Soldering:

   • Soldering temperature should not exceed 260°C.
   • Soldering time should be kept to a minimum, typically less than 10 seconds.

3. Electrical Connections:

   • Connect the anode (A) and cathode (K) terminals to the input circuit.
   • Connect the collector (C) and emitter (E) terminals to the output circuit.
   • Ensure correct polarity to avoid damage.

4. Power Supply:

   • The forward current (I_F) should not exceed 0.1 A continuously.
   • The peak forward current (I_F(P)) should not exceed 1.0 A for more than 10 ms.

5. Protection:

   • Use appropriate current-limiting resistors to protect the device from overcurrent.
   • Consider using transient voltage suppressors (TVS) to protect against voltage spikes.

6. Storage:

   • Store the device in a dry, cool place away from direct sunlight.
   • Handle with care to avoid static discharge, which can damage the device.

7. Testing:

   • Test the device under controlled conditions to ensure it meets the specified parameters.
   • Use a multimeter to check the continuity and resistance between the terminals.

By following these guidelines, you can ensure reliable operation and longevity of the TLP620-2(GB,F) optocoupler.

(For reference only)