Details

---

BUY CA3130E CA3130EZ CA3130 https://www.utsource.net/itm/p/9768355.html

Parameter	CA3130E	CA3130EZ	CA3130
Type	Operational Amplifier	Operational Amplifier	Operational Amplifier
Package	DIP-8	SOIC-8	DIP-8
Supply Voltage (V)	3 to 30	3 to 30	3 to 30
Input Bias Current (pA)	20	20	20
Input Offset Voltage (mV)	5	5	5
Slew Rate (V/渭s)	0.5	0.5	0.5
Bandwidth (MHz)	1.2	1.2	1.2
Output Current (mA)	10	10	10
Operating Temperature (掳C)	-40 to 125	-40 to 125	-40 to 125
Quiescent Current (渭A)	100	100	100
CMRR (dB)	90	90	90
PSRR (dB)	90	90	90
Input Voltage Range (V)	V- to V+ - 1.5	V- to V+ - 1.5	V- to V+ - 1.5
Output Voltage Swing (V)	V- + 0.1 to V+ - 1.5	V- + 0.1 to V+ - 1.5	V- + 0.1 to V+ - 1.5

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage is within the specified range (3 to 30V).
   • Connect the positive supply (V+) to pin 7 and the negative supply (V-) to pin 4.

2. Input Connections:

   • Connect the non-inverting input (pin 3) and inverting input (pin 2) as required by your circuit.
   • Use high impedance sources for best performance, as the input bias current is very low.

3. Output Connection:

   • The output (pin 6) can swing from V- + 0.1V to V+ - 1.5V. Connect this to your load or next stage of the circuit.

4. Feedback Loop:

   • For stable operation, use a feedback resistor between the output (pin 6) and the inverting input (pin 2).

5. Offset Nulling:

   • If required, use the offset null pins (1 and 5) to adjust the input offset voltage. Connect a potentiometer or resistors to these pins.

6. Temperature Considerations:

   • Ensure the operating temperature is within the specified range (-40 to 125掳C). Avoid exposing the device to extreme temperatures.

7. Handling:

   • Handle the device with care to avoid static damage. Use proper ESD protection when handling the device.

8. Storage:

   • Store the device in a dry, cool place to prevent moisture damage.

9. Mounting:

   • For the DIP-8 package, ensure proper spacing and alignment on the PCB. For the SOIC-8 package, use appropriate surface mount techniques.

10. Testing:

    • Before finalizing the design, test the circuit under various conditions to ensure it meets the required specifications.

(For reference only)