Details

---

BUY IRGP35B60PD https://www.utsource.net/itm/p/11245354.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Collector-Emitter Voltage	VCEO	-	-	600	V	IC = 25 A, Tj = 25掳C
Collector-Base Voltage	VCBO	-	-	600	V	IC = 0 A, Tj = 25掳C
Emitter-Base Voltage	VEBO	-	-	7	V	IE = 1 A, Tj = 25掳C
Continuous Collector Current	IC	-	-	35	A	TC = 25掳C
Power Dissipation	PTOT	-	-	350	W	TC = 25掳C
Junction Temperature	Tj	-	-	150	掳C	-
Storage Temperature	Tstg	-55	-	150	掳C	-
Gate Charge	Qg	-	45	60	nC	VGE = 卤15 V
Turn-On Delay Time	td(on)	-	45	75	ns	IC = 25 A, VGE = 15 V, RG = 10 惟
Rise Time	tr	-	70	100	ns	IC = 25 A, VGE = 15 V, RG = 10 惟
Turn-Off Delay Time	td(off)	-	40	60	ns	IC = 25 A, VGE = -15 V, RG = 10 惟
Fall Time	tf	-	60	90	ns	IC = 25 A, VGE = -15 V, RG = 10 惟

Instructions for Use:

1. Mounting and Heat Sinking:

   • Ensure proper heat sinking to maintain the junction temperature within the specified limits.
   • Use thermal compound between the transistor and the heat sink for better thermal conductivity.

2. Gate Drive:

   • Use a gate resistor (R_G) to control the switching speed and reduce electromagnetic interference (EMI).
   • Ensure the gate drive voltage (V_GE) is within the specified range to avoid damage.

3. Current Limiting:

   • Implement current limiting to protect the device from overcurrent conditions.
   • Use a current-sense resistor or a current-limiting circuit to monitor and limit the collector current (I_C).

4. Storage and Handling:

   • Store the device in a dry, cool place away from direct sunlight.
   • Handle with care to avoid static discharge, which can damage the device.

5. Testing:

   • Before mounting, test the device using a multimeter to ensure it is not damaged.
   • Follow the recommended test procedures and conditions as specified in the datasheet.

6. PCB Design:

   • Use wide and short traces for the power connections to minimize inductance and resistance.
   • Ensure adequate spacing between the device and other components to prevent overheating.

7. Safety Precautions:

   • Always wear appropriate personal protective equipment (PPE) when handling high-voltage circuits.
   • Follow all safety guidelines and regulations applicable to the application.

(For reference only)