Details

---

BUY MAX202CSE https://www.utsource.net/itm/p/11250586.html
IC TRANSCEIVER FULL 2/2 16SO

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Operating Voltage	Vcc		4.75	5	5.25	V
Output Current (High)	Ioh	Vo = 2.4V	-16	-10	-4	mA
Output Current (Low)	Iol	Vo = 2.4V	4	10	16	mA
Input Current	IIH	VI = 5V	0	1	10	μA
Input Current	IIL	VI = 0V	-10	-1	0	μA
Propagation Delay (Low to High)	tPLH	VI = 0V to VO = 2.4V	15	30	50	ns
Propagation Delay (High to Low)	tPHL	VI = 5V to VO = 2.4V	15	30	50	ns
Power Dissipation	PD	VI = 5V, VO = 2.4V		125		mW
Operating Temperature	Toper		-40		85	°C

Instructions for Using MAX202CSE

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the range of 4.75V to 5.25V.
   • Connect the Vcc pin to the positive terminal of your power source and GND to the ground.

2. Signal Levels:

   • For a high output level (VOH), the output current (Ioh) should be between -16mA and -4mA.
   • For a low output level (VOL), the output current (Iol) should be between 4mA and 16mA.
   • The input current (IIH) when the input is high (VI = 5V) should be between 0μA and 10μA.
   • The input current (IIL) when the input is low (VI = 0V) should be between -10μA and 0μA.

3. Propagation Delay:

   • The propagation delay from low to high (tPLH) and from high to low (tPHL) should be within 15ns to 50ns.

4. Power Dissipation:

   • The maximum power dissipation (PD) should not exceed 125mW.

5. Temperature Range:

   • The device can operate within a temperature range of -40°C to 85°C.

6. Handling:

   • Handle the device with care to avoid static damage.
   • Use proper grounding and anti-static measures when handling the device.

7. Schematic Integration:

   • Refer to the datasheet for detailed pin configurations and recommended layout practices.
   • Ensure all connections are secure and meet the specified electrical parameters.

8. Testing:

   • Before finalizing the design, test the device under various conditions to ensure it meets the required performance specifications.

9. Storage:

   • Store the device in a dry, cool place to prevent moisture damage.

10. Compliance:

    • Ensure that the device complies with all relevant safety and regulatory standards for your application.

(For reference only)