Details

---

BUY MT9V011P11STC https://www.utsource.net/itm/p/11251905.html

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (VDD)	Operating supply voltage	2.7	-	3.6	V
Standby Current	Current consumption in standby mode	-	50	-	μA
Active Current	Current consumption in active mode	100	120	140	mA
Pixel Array Size	Active pixel array dimensions	-	1280 x 960	-	pixels
Frame Rate	Maximum frame rate	-	60	-	fps
Pixel Size	Physical size of each pixel	-	3.75	-	μm
Sensitivity	Minimum light level for operation	-	2.5	-	lux
Dynamic Range	Range of light levels that can be captured	-	60	-	dB
Power-down Mode	Low power state for minimal power consumption	-	-	-	-
Operating Temperature	Temperature range for normal operation	-40	-	85	°C
Storage Temperature	Temperature range for storage	-55	-	125	°C

Instructions:

1. Power Supply:

   • Connect the VDD pin to a stable power supply within the range of 2.7V to 3.6V.
   • Ensure the power supply is clean and has adequate current capacity to support the active current of 120mA.

2. Power Management:

   • To enter standby mode, set the appropriate control signal to low. The device will consume approximately 50μA in this mode.
   • To enter power-down mode, set the power-down control signal to high. This will minimize power consumption further.

3. Operation:

   • The device supports a maximum frame rate of 60 fps with a pixel array size of 1280 x 960.
   • Ensure the sensor is exposed to a minimum light level of 2.5 lux for optimal performance.

4. Environmental Conditions:

   • Operate the device within the temperature range of -40°C to 85°C for reliable performance.
   • Store the device within the temperature range of -55°C to 125°C to avoid damage.

5. Handling:

   • Handle the device with care to avoid static discharge, which can damage sensitive components.
   • Use proper ESD protection when handling the device.

6. Mounting:

   • Follow the recommended PCB layout guidelines to ensure proper thermal management and signal integrity.
   • Use appropriate mounting techniques to secure the device on the PCB.

7. Testing:

   • Before final assembly, test the device to ensure it meets the specified parameters and operates correctly.
   • Use a calibrated light source to verify the sensitivity and dynamic range.

(For reference only)