Details

---

BUY AD537JD https://www.utsource.net/itm/p/11252105.html
IC V/F CONV 14-CDIP

Parameter	Description	Min	Typ	Max	Unit
V+	Supply Voltage	4.5	-	18	V
I+	Supply Current	-	2.5	-	mA
V-	Negative Supply Voltage	-18	-	-4.5	V
I-	Negative Supply Current	-	0.1	-	mA
VOUT	Output Voltage Range	V- + 0.1	-	V+ - 0.1	V
IOUT	Output Current	-	10	-	mA
CMRR	Common Mode Rejection Ratio	80	-	-	dB
PSRR	Power Supply Rejection Ratio	80	-	-	dB
Slew Rate	Slew Rate	0.5	-	1.5	V/μs
Bandwidth	Unity Gain Bandwidth	1	-	10	MHz
Input Offset Voltage	Input Offset Voltage	-	0.5	-	mV
Input Bias Current	Input Bias Current	-	50	-	nA
Temperature Range	Operating Temperature	-40	-	85	°C

Instructions for Using AD537JD

1. Power Supply:

   • Connect the positive supply voltage (V+) to the V+ pin.
   • Connect the negative supply voltage (V-) to the V- pin.
   • Ensure the supply voltages are within the specified range.

2. Input Signal:

   • Apply the input signal to the non-inverting (IN+) and inverting (IN-) inputs.
   • The input signals should be within the common mode input range, which is typically from V- + 0.1V to V+ - 0.1V.

3. Output Configuration:

   • Connect the output (VOUT) to the load or next stage circuit.
   • Ensure the output current does not exceed the maximum specified limit.

4. Biasing and Compensation:

   • For optimal performance, use external compensation components as recommended in the datasheet.
   • Ensure proper biasing of the input and output stages to avoid distortion.

5. Temperature Considerations:

   • Operate the device within the specified temperature range to ensure reliable performance.
   • Use appropriate heat sinking if operating at high temperatures or high power levels.

6. Testing and Troubleshooting:

   • Before finalizing the design, test the circuit under various conditions to ensure stability and performance.
   • Use an oscilloscope to monitor the output waveform and check for any distortion or instability.

7. Storage and Handling:

   • Store the device in a dry, cool environment to prevent damage.
   • Handle the device with care to avoid static discharge, which can damage the internal circuits.

(For reference only)