Details

---

BUY S9018 https://www.utsource.net/itm/p/11252840.html

Parameter	Symbol	Min	Typical	Max	Unit	Conditions
Collector-Emitter Voltage	VCEO	-	-	50	V
Collector-Base Voltage	VCBO	-	-	60	V
Emitter-Base Voltage	VEBO	-	-	5	V
Collector Current	IC	-	-	200	mA
Base Current	IB	-	-	20	mA
DC Current Gain	hFE	100	300	800	-	IC = 10mA, VCE = 5V
Transition Frequency	fT	-	150	300	MHz
Power Dissipation	PD	-	-	625	mW	Ta = 25掳C
Storage Temperature Range	Tstg	-55	-	150	掳C
Operating Temperature Range	Topr	-40	-	125	掳C

Instructions for Use:

1. Handling Precautions:

   • Handle the S9018 with care to avoid static damage.
   • Use proper anti-static measures when handling the device.

2. Mounting:

   • Ensure that the mounting surface is clean and free of contaminants.
   • Apply appropriate thermal paste if heat dissipation is required.
   • Soldering temperature should not exceed 260掳C for more than 10 seconds.

3. Biasing:

   • Ensure that the base-emitter voltage (VBE) is within the specified range to avoid damage.
   • Use a current-limiting resistor on the base to prevent excessive base current.

4. Operating Conditions:

   • Do not exceed the maximum ratings listed in the table.
   • Ensure that the power dissipation does not exceed the maximum rating by providing adequate cooling if necessary.

5. Storage:

   • Store the S9018 in a dry, cool place away from direct sunlight and high humidity.
   • Keep the device in its original packaging until ready for use to protect against static discharge.

6. Testing:

   • Use a multimeter or transistor tester to verify the functionality of the S9018 before installation.
   • Test the device under controlled conditions to ensure it meets the specified parameters.

7. Troubleshooting:

   • If the S9018 fails to operate correctly, check for proper biasing, correct polarity, and any short circuits or open circuits in the circuit.
   • Replace the S9018 if it is found to be defective.

(For reference only)