Details

---

BUY DMN6075S-7 https://www.utsource.net/itm/p/11552061.html

Parameter	Symbol	Test Conditions	Min	Typical	Max	Unit
Drain-Source Voltage	VDS	-	-	-	60	V
Gate-Source Voltage	VGS	-	-	-	卤20	V
Continuous Drain Current	ID	TC = 25掳C	-	-	7.5	A
Continuous Drain Current	ID	TC = 70掳C	-	-	5.3	A
Pulse Drain Current	IDM	tp = 10 渭s, IG = 10 A	-	40	-	A
Total Power Dissipation	PTOT	TC = 25掳C	-	-	115	W
Junction Temperature	TJ	-	-	-	150	掳C
Storage Temperature Range	TSTG	-	-65	-	150	掳C
Gate Charge	QG	VGS = 10 V, ID = 1 A	-	22	-	nC
Input Capacitance	Ciss	VDS = 10 V, f = 1 MHz	-	1800	-	pF
Output Capacitance	Coss	VDS = 10 V, f = 1 MHz	-	120	-	pF
RDS(on) at VGS = 10 V	RDS(on)	ID = 7.5 A, TC = 25掳C	-	0.025	-	惟
RDS(on) at VGS = 4.5 V	RDS(on)	ID = 7.5 A, TC = 25掳C	-	0.035	-	惟

Instructions for Use:

1. Handling and Storage:

   • Store the DMN6075S-7 in a dry environment to prevent moisture damage.
   • Handle with care to avoid mechanical stress on the leads and body.

2. Mounting:

   • Ensure proper thermal management by using a heat sink if necessary.
   • Soldering temperature should not exceed 260掳C for more than 10 seconds.

3. Electrical Connections:

   • Apply gate-source voltage (V_GS) within the specified range to avoid damage.
   • Ensure that the drain-source voltage (V_DS) does not exceed 60V to prevent breakdown.

4. Thermal Considerations:

   • Monitor the junction temperature (T_J) to ensure it does not exceed 150掳C.
   • Use appropriate cooling methods to maintain the device within its operational temperature range.

5. Pulse Operation:

   • For pulse operations, ensure that the pulse duration and current do not exceed the specified limits to avoid overheating and potential failure.

6. Testing:

   • Use the specified test conditions when measuring parameters to ensure accurate results.
   • Regularly inspect the device for signs of wear or damage.

7. Safety:

   • Always follow safe electrical practices to avoid injury or damage to equipment.
   • Ensure that the device is properly insulated and grounded during operation.

(For reference only)