Details

---

BUY FAN8036L https://www.utsource.net/itm/p/11554629.html
IC OP AMP 5CH MOTOR DVR 48QFP

Parameter	Symbol	Min	Typical	Max	Unit	Description
Supply Voltage	VCC	4.5	5.0	5.5	V	Operating supply voltage range
Quiescent Current	IQ	-	1.2	1.8	mA	Quiescent current at no load
Output Current	IO	0	1.5	2.0	A	Maximum output current
Shutdown Current	ISD	-	1.0	2.0	μA	Shutdown mode current
Enable Input High Level	VENH	1.2	1.5	2.0	V	Minimum enable input high level
Enable Input Low Level	VENL	-	0.8	1.0	V	Maximum enable input low level
Thermal Shutdown	TSD	-	160	-	°C	Temperature at which thermal shutdown is initiated
Junction Temperature	TJ	-40	-	150	°C	Operating junction temperature range
Storage Temperature	TSTG	-65	-	150	°C	Storage temperature range

Instructions for Using FAN8036L

1. Power Supply Connection:

   • Connect the VCC pin to the positive supply voltage (4.5V to 5.5V).
   • Connect the GND pin to the ground.

2. Enable Pin:

   • To activate the device, apply a voltage greater than VENH (1.5V typical) to the EN pin.
   • To shut down the device, apply a voltage less than VENL (0.8V typical) to the EN pin.

3. Output Load:

   • Connect the load between the OUT pin and ground. Ensure the load current does not exceed the maximum output current (2.0A typical).

4. Thermal Management:

   • Ensure adequate heat dissipation to prevent the junction temperature from exceeding 150°C. Use a heatsink if necessary.

5. Storage and Handling:

   • Store the device in a temperature range of -65°C to 150°C.
   • Handle with care to avoid damage from electrostatic discharge (ESD).

6. Testing and Verification:

   • Verify the quiescent current (IQ) and shutdown current (ISD) to ensure proper operation.
   • Test the device under load conditions to confirm it meets the required performance specifications.

7. Safety Precautions:

   • Do not exceed the maximum ratings specified in the table to avoid damaging the device.
   • Follow proper handling and soldering procedures to prevent damage during assembly.

(For reference only)