Details

---

BUY PIC16F630-I/SL https://www.utsource.net/itm/p/11558734.html
IC MCU 8BIT 1.75KB FLASH 14SOIC

Parameter	Description	Value
Package Type	Type of package	SOT-23-6 (SC-59)
Operating Voltage (Vdd)	Range of supply voltage	2.0 V to 5.5 V
Operating Temperature	Range of operating temperature	-40°C to +85°C
Program Memory	Type and size of program memory	1K x 14 Flash
Data Memory (RAM)	Size of data memory	64 x 8 bytes
EEPROM Data Memory	Size of EEPROM data memory	64 x 8 bytes
Clock Speed	Maximum clock speed	20 MHz
I/O Pins	Number of I/O pins	8
Analog-to-Digital Converter (ADC)	Number of ADC channels	7
Comparator	Number of comparators	1
Timer/Counter Modules	Number of timer/counter modules	1 (8-bit Timer0)
Watchdog Timer (WDT)	Availability of watchdog timer	Yes
Brown-out Reset (BOR)	Availability of brown-out reset	Yes
Low-Voltage Programming (LVP)	Availability of low-voltage programming	No
Power Consumption	Typical power consumption at 3.0 V, 4 MHz	2 mA
Power Consumption (Sleep Mode)	Typical power consumption in sleep mode at 3.0 V	1 μA

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage (Vdd) is within the range of 2.0 V to 5.5 V.
   • Connect the Vss pin to ground and the Vdd pin to the positive supply.

2. Programming:

   • Use a programmer compatible with the PIC16F630.
   • The device supports In-Circuit Serial Programming (ICSP) through the ICSP pins.

3. Clock Configuration:

   • The device can be configured to use an internal oscillator or an external clock source.
   • Set the configuration bits in the code to select the desired clock source.

4. I/O Configuration:

   • Configure the I/O pins as inputs or outputs using the TRIS register.
   • Use the PORT register to read or write to the I/O pins.

5. Analog-to-Digital Conversion:

   • Configure the ADC module by setting the appropriate registers (ADCON0, ADCON1).
   • Select the channel to be converted and start the conversion process.

6. Comparator:

   • Configure the comparator by setting the CMCON register.
   • Connect the input signals to the comparator pins and read the output from the CMOUT bit.

7. Timer/Counter:

   • Configure the Timer0 module by setting the T0CON register.
   • Start the timer by enabling it in the T0CON register and read the timer value from the TMR0 register.

8. Watchdog Timer:

   • Enable the WDT by setting the appropriate configuration bit.
   • Clear the WDT periodically to prevent a reset.

9. Brown-out Reset:

   • Enable BOR by setting the appropriate configuration bit.
   • The device will reset if the supply voltage drops below the BOR threshold.

10. Low-Power Modes:

    • Enter sleep mode by executing the SLEEP instruction.
    • The device will consume minimal power in sleep mode.

11. Low-Voltage Programming:

    • This device does not support low-voltage programming (LVP).

12. EEPROM Data Memory:

    • Use the EEADR, EEDATA, and EECON1 registers to read from and write to the EEPROM.
    • Follow the sequence of operations to ensure proper write cycles.

For detailed information, refer to the datasheet and application notes provided by Microchip Technology.

(For reference only)