Details

---

BUY TAS5751MDCAR https://www.utsource.net/itm/p/11610536.html
IC AMP CLASS D STER 25W 48HTSSOP

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VDD	2.7	3.3	5.5	V
Operating Temperature	Toper	-40		85	°C
Storage Temperature	Tstg	-65		150	°C
Output Power (Per Channel)	POUT		2.5	5.0	W
Efficiency	η		90		%
Signal-to-Noise Ratio	SNR		105		dB
Total Harmonic Distortion	THD+N		0.001		%
Input Voltage Range	VIN	0.3	1.2	2.1	Vpp
Sampling Rate	fs	8		192	kHz
Power Consumption	IDD		150	300	mA

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 2.7V to 5.5V.
   • Use a stable power source to avoid fluctuations that can affect performance.

2. Temperature Considerations:

   • Operate the device within the temperature range of -40°C to 85°C for optimal performance.
   • Store the device between -65°C and 150°C.

3. Output Configuration:

   • The TAS5751MDCAR can deliver up to 5.0W per channel with a typical output power of 2.5W.
   • Ensure the load impedance is appropriate for the desired output power.

4. Signal Quality:

   • The signal-to-noise ratio (SNR) is typically 105dB, providing high audio clarity.
   • Keep the total harmonic distortion plus noise (THD+N) below 0.001% for high-fidelity sound.

5. Input Signal:

   • The input voltage range should be between 0.3Vpp and 2.1Vpp.
   • Ensure the input signal is within this range to avoid clipping or underdriving the amplifier.

6. Sampling Rate:

   • The device supports sampling rates from 8kHz to 192kHz.
   • Choose the appropriate sampling rate based on the application requirements.

7. Power Consumption:

   • The typical power consumption is 150mA, with a maximum of 300mA.
   • Monitor power consumption to ensure it does not exceed the maximum rating.

8. Installation:

   • Follow the recommended PCB layout guidelines to minimize noise and interference.
   • Use proper grounding techniques to ensure stable operation.

9. Testing:

   • Before deploying the device, conduct thorough testing to verify all parameters meet the specified values.
   • Use a multimeter and oscilloscope to measure voltage, current, and signal quality.

10. Safety:

    • Always follow safety guidelines when handling electronic components.
    • Avoid short circuits and excessive heat during installation and operation.

(For reference only)