Details

---

BUY MAX454CPD https://www.utsource.net/itm/p/11614144.html
IC AMP MPLEX AMP 14DIP

Parameter	Symbol	Min	Typical	Max	Unit
Supply Voltage	VCC	2.7	-	5.5	V
Supply Current	ICC	-	100	-	μA
Input Offset Voltage	VOS	-	1.5	-	mV
Input Bias Current	IB	-	10	-	nA
Input Resistance	RIN	-	10^12	-	Ω
Output Voltage Swing	VOUT	0	-	VCC-1.5	V
Bandwidth (Small Signal)	fBW	-	300	-	kHz
Slew Rate	SR	-	0.3	-	V/μs
Common-Mode Input Range	VCM	0	-	VCC-1.5	V
Differential Input Voltage	VID	-	-	±30	V
Operating Temperature	TOP	-40	-	85	°C

Instructions for Using MAX454CPD

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the range of 2.7V to 5.5V.
   • Connect the V_CC pin to the positive supply and GND to the ground.

2. Input Connections:

   • Connect the input signals to the IN+ and IN- pins.
   • Ensure the common-mode input voltage (V_CM) is within the range of 0V to V_CC - 1.5V.
   • The differential input voltage (V_ID) should not exceed ±30V.

3. Output Connections:

   • The output voltage swing (V_OUT) can range from 0V to V_CC - 1.5V.
   • Connect the output to the load or next stage of your circuit.

4. Biasing and Offset:

   • The input bias current (I_B) is typically 10nA, so ensure that the source impedance is low enough to minimize errors.
   • The input offset voltage (V_OS) is typically 1.5mV. Use a trimmer potentiometer or other compensation techniques if necessary to reduce offset errors.

5. Temperature Considerations:

   • The device is rated for operation from -40°C to 85°C. Ensure the operating environment does not exceed these limits to avoid damage or performance degradation.

6. Handling and Storage:

   • Handle the device with care to avoid static damage. Use ESD protection measures when handling.
   • Store the device in a dry, cool place to prevent moisture damage.

7. Testing and Troubleshooting:

   • Before finalizing the design, test the device under various conditions to ensure it meets the required specifications.
   • If the device does not perform as expected, check for proper power supply connections, input signal levels, and output loading.

By following these instructions, you can ensure optimal performance and reliability of the MAX454CPD in your application.

(For reference only)