Details

---

BUY TL082CN https://www.utsource.net/itm/p/11624427.html
IC OPAMP JFET 2 CIRCUIT 8DIP

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VCC	卤4	卤15	卤18	V
Input Voltage Range	VI	VEE + 1.5	-	VCC - 1.5	V
Output Voltage Swing	VO	VEE + 3	-	VCC - 3	V
Input Offset Voltage	VIO	-15	5	15	渭V
Input Bias Current	IB	40	80	120	nA
Input Offset Current	IOS	-10	2	10	nA
Input Resistance	RI	-	1012	-	惟
Differential Input Voltage Range	VID	-	30	-	V
Slew Rate	SR	-	13	-	V/渭s
Large Signal Voltage Gain	AV	-	40000	-	V/V
Bandwidth (Unity Gain)	fT	-	3	-	MHz
Power Consumption	Ptot	-	1.4	-	mW

Instructions for Using TL082CN

1. Supply Voltage:

   • The TL082CN can operate with a supply voltage range from 卤4V to 卤18V. Ensure that the supply voltages are within this range to avoid damage.

2. Input Voltage Range:

   • The input voltage should be within the range of V_EE + 1.5V to V_CC - 1.5V. Exceeding these limits can cause distortion or damage.

3. Output Voltage Swing:

   • The output voltage swing is limited to V_EE + 3V to V_CC - 3V. Design your circuit to ensure the output does not exceed these limits.

4. Input Offset Voltage:

   • The input offset voltage can vary from -15渭V to 15渭V. This can affect the accuracy of your circuit, especially in precision applications.

5. Input Bias Current:

   • The input bias current ranges from 40nA to 120nA. Use high-impedance sources to minimize the effect of this current.

6. Input Offset Current:

   • The input offset current can range from -10nA to 10nA. This can also impact precision applications.

7. Input Resistance:

   • The input resistance is approximately 10¹²惟, making it suitable for high-impedance sources.

8. Differential Input Voltage Range:

   • The differential input voltage range is up to 30V. Ensure that the difference between the two inputs does not exceed this value.

9. Slew Rate:

   • The slew rate is typically 13V/渭s. This limits the maximum rate of change of the output voltage and affects the performance at high frequencies.

10. Large Signal Voltage Gain:

    • The large signal voltage gain is typically 40,000 V/V. This high gain makes the TL082CN suitable for amplifying small signals.

11. Bandwidth (Unity Gain):

    • The bandwidth at unity gain is typically 3MHz. This determines the frequency range over which the op-amp can effectively amplify signals.

12. Power Consumption:

    • The total power consumption is typically 1.4mW. This is important for power budgeting in low-power designs.

Additional Notes:

• Always refer to the datasheet for the most accurate and detailed information.
• Proper decoupling capacitors should be used near the power supply pins to ensure stable operation.
• When designing circuits, consider the temperature range and environmental conditions to ensure reliable performance.

(For reference only)