Details

---

BUY DS26LS32CM https://www.utsource.net/itm/p/11627152.html
IC RECEIVER 0/4 16SOIC

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Supply Voltage	VCC	4.75	5.0	5.25	V
Output High Voltage	VOH	2.4	3.5	5.0	V	@ IOL = -4mA, VCC = 5V
Output Low Voltage	VOL	0	0.4	0.5	V	@ IOH = 4mA, VCC = 5V
Input High Voltage	VIH	2.0		5.0	V
Input Low Voltage	VIL	0		0.8	V
Propagation Delay Time	tpd		11	22	ns	@ VCC = 5V, TA = 25°C
Power Dissipation	PD		125		mW	@ VCC = 5V, f = 10MHz
Operating Temperature	TA	-40		85	°C
Storage Temperature	Tstg	-65		150	°C

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the range of 4.75V to 5.25V.
   • Connect the ground (GND) pin to a stable reference ground.

2. Input Signals:

   • Input signals should be within the specified input voltage levels (VIL and VIH).
   • Avoid applying voltages outside the VCC and GND range to prevent damage.

3. Output Signals:

   • The output high (VOH) and low (VOL) voltages are specified for typical operating conditions.
   • Ensure that the load connected to the output does not exceed the maximum current ratings.

4. Propagation Delay:

   • The propagation delay time (tpd) is critical for timing considerations in digital circuits.
   • Use the typical value for design calculations and ensure the maximum value is accounted for in worst-case scenarios.

5. Temperature Considerations:

   • Operate the device within the specified operating temperature range (-40°C to 85°C).
   • Store the device within the storage temperature range (-65°C to 150°C).

6. Handling:

   • Handle the device with care to avoid static discharge, which can damage sensitive components.
   • Follow proper ESD (Electrostatic Discharge) handling procedures.

7. Mounting:

   • Ensure proper mounting and soldering techniques to maintain electrical and mechanical integrity.
   • Use appropriate thermal management techniques if operating at high power or in high-temperature environments.

8. Testing:

   • Test the device under controlled conditions to verify its performance before integrating it into a larger system.
   • Use the specified test conditions (e.g., VCC = 5V, TA = 25°C) for accurate measurements.

(For reference only)