Details

---

BUY ILD30 DIP8 https://www.utsource.net/itm/p/11633880.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	Vcc	4.5	5	5.5	V	Operating voltage range
Output Current per Channel	Iout	-	30	-	mA	Maximum output current per channel
Number of Channels	Nch	-	8	-	-	Number of output channels
Operating Temperature	Toper	-40	-	85	掳C	Operating temperature range
Storage Temperature	Tstg	-65	-	150	掳C	Storage temperature range
Quiescent Current	Iq	-	10	-	渭A	Quiescent current at no load
Output Low Voltage	Vol	-	0.2	-	V	Output voltage when low (sink)
Output High Voltage	Voh	-	4.8	-	V	Output voltage when high (source)
Propagation Delay Time	tpd	-	10	-	ns	Time delay between input and output
Input Capacitance	Cin	-	10	-	pF	Input capacitance
Output Capacitance	Cout	-	10	-	pF	Output capacitance

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage is within the specified range (4.5V to 5.5V).
   • Connect the Vcc pin to the positive terminal of the power supply and GND to the ground.

2. Channel Configuration:

   • The ILD30 DIP8 has 8 output channels, each capable of sourcing or sinking up to 30mA.
   • Connect the load to the appropriate output pins (OUT1 to OUT8) and ensure the common ground is connected to GND.

3. Input Control:

   • Apply logic high (Vcc) to the input pins (IN1 to IN8) to turn on the corresponding output channels.
   • Apply logic low (GND) to the input pins to turn off the corresponding output channels.

4. Temperature Considerations:

   • Operate the device within the specified operating temperature range (-40掳C to 85掳C).
   • Store the device within the storage temperature range (-65掳C to 150掳C).

5. Quiescent Current:

   • The quiescent current is typically 10渭A when no load is connected. This should be considered in low-power applications.

6. Output Levels:

   • When the output is low, the output voltage will be approximately 0.2V.
   • When the output is high, the output voltage will be approximately 4.8V.

7. Propagation Delay:

   • The propagation delay time is typically 10ns. This is the time it takes for the output to change state after the input changes.

8. Capacitance:

   • The input and output capacitances are both typically 10pF. This can affect the speed of signal transitions in high-frequency applications.

9. Handling:

   • Handle the device with care to avoid static damage.
   • Follow proper soldering techniques to ensure reliable connections.

10. Testing:

    • Before final assembly, test the device with a simple load to verify functionality.
    • Use a multimeter to check the output voltages and currents to ensure they meet the specifications.

(For reference only)