Details

---

BUY 74HC595AG MC74HC595ADR2G HC595AG SOP-16 ON https://www.utsource.net/itm/p/11649513.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	2.0	-	6.0	V
Output High-Level Voltage	VOH	IOH = -0.4mA, VCC = 4.5V to 5.5V	2.4	-	VCC	V
Output Low-Level Voltage	VOL	IOL = 8.0mA, VCC = 4.5V to 5.5V	0	-	0.1	V
Input Low-Level Voltage	VIL	VI = 0V to VCC	0	-	0.8	V
Input High-Level Voltage	VIH	VI = 0V to VCC	2.0	-	VCC	V
Storage Temperature	Tstg	-	-65	-	150	掳C
Operating Temperature	Topr	-	0	-	70	掳C
Output Current (High)	IOH	VOH = 2.4V, VCC = 4.5V to 5.5V	-	-	-4	mA
Output Current (Low)	IOL	VOL = 0.4V, VCC = 4.5V to 5.5V	-	-	32	mA
Power Dissipation	PD	-	-	-	100	mW

Instructions for Using 74HC595AG MC74HC595ADR2G HC595AG SOP-16

1. Pin Configuration:

   • 1 (DS): Serial Data Input
   • 2 (SH_CP): Shift Register Clock Input (rising edge triggered)
   • 3 (ST_CP): Storage Register Clock Input (rising edge triggered)
   • 4 (MR): Master Reset (active low)
   • 5 (OE): Output Enable (active low)
   • 6-13 (Q0-Q7): Parallel Output
   • 14 (SER): Serial Output
   • 15 (Q7S): Serial Output from Shift Register
   • 16 (VCC): Positive Supply Voltage
   • 8 (GND): Ground

2. Basic Operation:

   • Shift Register Mode:
     • Set MR high to enable the device.
     • Set OE low to enable outputs.
     • Load data serially into the shift register by toggling SH_CP while DS is set to the desired bit value.
   • Storage Register Mode:
     • After loading the shift register, pulse ST_CP to transfer the data from the shift register to the storage register.
     • The data in the storage register will appear on the parallel outputs Q0-Q7.

3. Resetting the Device:

   • To reset the device, set MR low. This will clear all the registers.

4. Powering the Device:

   • Connect VCC to the positive supply voltage (2.0V to 6.0V).
   • Connect GND to ground.

5. Output Control:

   • To disable the outputs, set OE high.
   • To enable the outputs, set OE low.

6. Handling Static Electricity:

   • Handle the device with care to avoid damage from static electricity. Use proper ESD protection measures.

7. Temperature Considerations:

   • Ensure that the operating temperature is within the specified range (0掳C to 70掳C) to avoid performance issues or damage.

8. Power Dissipation:

   • Ensure that the power dissipation does not exceed 100mW to prevent overheating and potential damage to the device.

By following these instructions, you can effectively use the 74HC595AG MC74HC595ADR2G HC595AG SOP-16 in your circuits.

(For reference only)