Details

---

BUY CS5509-AS https://www.utsource.net/itm/p/11655146.html

Parameter	Description	Value/Range
Device	High Performance 16-bit Analog-to-Digital Converter (ADC) with I2C Interface	CS5509-AS
Supply Voltage (VDD)	Operating Supply Voltage	2.7 V to 5.25 V
I2C Interface	Communication Protocol	Standard and Fast Mode
Resolution	ADC Resolution	16 bits
Conversion Time	Time to Complete a Conversion	33 ms (Max)
Input Range	Analog Input Voltage Range	0 V to VDD
Power Consumption	Typical Power Consumption	300 渭A (Active), 1 渭A (Shutdown)
Temperature Range	Operating Temperature Range	-40掳C to +85掳C
Package	Package Type	SOIC-8

Instructions for Use

1. Power Supply:

   • Connect the VDD pin to a power supply within the range of 2.7 V to 5.25 V.
   • Connect the GND pin to the ground.

2. I2C Configuration:

   • Connect the SDA (Data) and SCL (Clock) pins to the I2C bus.
   • Ensure pull-up resistors are connected to both SDA and SCL lines to VDD.

3. Initialization:

   • Send a start condition followed by the device address (0x90 for write, 0x91 for read).
   • Write the configuration register to set the desired mode (e.g., single conversion, continuous conversion).

4. Conversion:

   • To start a conversion, write to the control register.
   • For single conversion mode, the device will perform one conversion and then enter idle mode.
   • For continuous conversion mode, the device will continuously perform conversions.

5. Reading Data:

   • After the conversion is complete, send a start condition followed by the device address for read.
   • Read the data from the data register (16-bit value).

6. Shutdown Mode:

   • To reduce power consumption, write to the control register to enter shutdown mode.
   • The device will consume approximately 1 渭A in this mode.

7. Temperature Considerations:

   • Ensure the operating temperature is within the specified range (-40掳C to +85掳C).

8. Handling Static Electricity:

   • Handle the device with care to avoid damage from static electricity.

9. Decoupling Capacitors:

   • Place decoupling capacitors close to the VDD and GND pins to ensure stable operation. Typically, a 0.1 渭F capacitor is recommended.

(For reference only)