Details

---

BUY HP2564 https://www.utsource.net/itm/p/11656117.html

Parameter	Description
Part Number	HP2564
Function	Programmable DC Power Supply
Output Voltage	0 to 60V (in 1V steps)
Output Current	0 to 5A (in 10mA steps)
Output Channels	Single Channel
Remote Sensing	Yes
Programming Interface	RS-232, GPIB
Display	LED display for voltage and current settings
Protection	Overvoltage, overcurrent, overpower protection
Dimensions	8.75" x 19" x 14.5"
Weight	20 lbs

Instructions

1. Power On:

   • Connect the power supply to a suitable power source using the provided AC power cord.
   • Turn on the power supply using the power switch located on the front panel.

2. Setting Voltage and Current:

   • Use the front panel controls to set the desired output voltage and current limit.
   • Adjust the voltage and current settings by turning the respective knobs or using the keypad if available.

3. Connecting Load:

   • Connect your load to the output terminals ensuring correct polarity.
   • For accurate regulation under load, use remote sensing leads if necessary.

4. Remote Control:

   • Connect an external controller via the RS-232 or GPIB interface.
   • Use the programming manual to send commands to control the power supply remotely.

5. Monitoring:

   • Observe the LED display to monitor the actual output voltage and current.
   • Ensure that the values do not exceed the preset limits to avoid triggering protective mechanisms.

6. Shutting Down:

   • Turn off the output using the front panel controls before disconnecting any loads.
   • Switch off the power supply using the power switch and unplug it from the power source.

7. Safety Precautions:

   • Always ensure that the input voltage matches the power supply specifications.
   • Do not operate the device in environments exceeding recommended temperature and humidity levels.
   • Regularly inspect connections and cables for damage or wear.

(For reference only)