Details

---

BUY LT1014CN https://www.utsource.net/itm/p/11702453.html
IC OPAMP GP 4 CIRCUIT 14DIP

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Continuous Operation	2.7	-	36.0	V
Quiescent Current	IQ	Per Amplifier, VCC = 5V	-	300	-	渭A
Input Offset Voltage	VOS	VCC = 卤15V	-	2.0	-	mV
Input Bias Current	IB	VCC = 卤15V	-	20	-	nA
Input Voltage Range	VIN	VCC = 卤15V	-14	-	+14	V
Output Voltage Swing	VOUT	No Load, VCC = 卤15V	-14	-	+14	V
Slew Rate	SR	VCC = 卤15V	-	13	-	V/渭s
Bandwidth	BW	VCC = 卤15V, G = +1	-	8	-	MHz
Common Mode Rejection Ratio	CMRR	VCC = 卤15V	-	90	-	dB
Power Supply Rejection Ratio	PSRR	VCC = 卤15V	-	90	-	dB

Instructions for Using LT1014CN

1. Supply Voltage:

   • The LT1014CN can operate from a single supply voltage ranging from 2.7V to 36V or dual supplies up to 卤18V.
   • Ensure the supply voltage is within the specified range to avoid damage to the device.

2. Quiescent Current:

   • Each amplifier in the quad package draws approximately 300 渭A of quiescent current at 5V.
   • This value helps in power budgeting for low-power applications.

3. Input Offset Voltage:

   • The input offset voltage is typically 2.0 mV at 卤15V supply.
   • Use this parameter to calibrate or compensate for any offsets in precision applications.

4. Input Bias Current:

   • The input bias current is typically 20 nA at 卤15V supply.
   • This is important for high-impedance input circuits to minimize errors.

5. Input Voltage Range:

   • The input voltage range is from -14V to +14V when operating with 卤15V supplies.
   • Ensure that input signals do not exceed these limits to prevent distortion or damage.

6. Output Voltage Swing:

   • The output voltage swing is from -14V to +14V with no load at 卤15V supplies.
   • For maximum output swing, ensure the load resistance is appropriate and does not pull the output too close to the supply rails.

7. Slew Rate:

   • The slew rate is typically 13 V/渭s at 卤15V supplies.
   • This parameter is crucial for high-frequency applications to ensure the amplifier can follow fast-changing signals.

8. Bandwidth:

   • The bandwidth is typically 8 MHz at 卤15V supplies with a gain of +1.
   • This indicates the frequency range over which the amplifier can operate effectively.

9. Common Mode Rejection Ratio (CMRR):

   • The CMRR is typically 90 dB at 卤15V supplies.
   • High CMRR ensures that common-mode signals are rejected, maintaining the integrity of differential signals.

10. Power Supply Rejection Ratio (PSRR):

    • The PSRR is typically 90 dB at 卤15V supplies.
    • High PSRR ensures that variations in the supply voltage do not significantly affect the output signal.

Additional Notes:

• Always refer to the datasheet for more detailed information and specific application notes.
• Proper decoupling capacitors should be used near the power supply pins to ensure stable operation.
• The LT1014CN is suitable for a wide range of analog applications, including signal conditioning, filtering, and amplification.

(For reference only)