Details

---

BUY TBD62084AFWG,EL https://www.utsource.net/itm/p/11721004.html
IC LOAD SWITCH 8CH 0.5A 18PSOP

Parameter	Description	Value
Part Number	Device Part Number	TBD62084AFWG,EL
Function	High-Voltage, High-Speed, 3-Channel Gate Driver	-
Supply Voltage (Vcc)	Operating Supply Voltage Range	7.5V to 60V
Output Current	Peak Output Current per Channel	±1.5A
Propagation Delay	Typical Propagation Delay Time (tPLH, tPHL)	30ns
Operating Temperature	Operating Ambient Temperature Range	-40°C to +125°C
Package	Package Type	SSOP-B20
Pin Count	Number of Pins	20
Isolation Voltage	Isolation Voltage Between Input and Output	2500Vrms
Input Logic Level	Compatible Input Logic Levels	CMOS/TTL
Protection Features	Built-in Protection Features	Under-Voltage Lockout
Storage Temperature	Storage Temperature Range	-55°C to +150°C

Instructions for Use

1. Power Supply Connection:

   • Connect the Vcc pin to the power supply voltage within the specified range (7.5V to 60V).
   • Ensure the GND pin is connected to the system ground.

2. Input Signal:

   • Apply the input signals to the IN1, IN2, and IN3 pins. These pins are compatible with CMOS and TTL logic levels.
   • The device will drive the corresponding output channels based on the input signals.

3. Output Configuration:

   • The OUT1, OUT2, and OUT3 pins are the high-voltage, high-speed outputs that can source or sink up to ±1.5A peak current.
   • Ensure the load is properly connected to these pins and grounded as required.

4. Protection:

   • The device includes under-voltage lockout protection. If the supply voltage drops below the threshold, the outputs will be disabled to prevent damage.

5. Thermal Management:

   • Ensure adequate heat dissipation by mounting the device on a heatsink if operating at high currents or in high ambient temperatures.

6. Isolation:

   • The device provides 2500Vrms isolation between the input and output, which is crucial for applications requiring electrical isolation.

7. Storage and Handling:

   • Store the device in a dry environment within the temperature range of -55°C to +150°C.
   • Handle with care to avoid static discharge, which can damage the device.

8. Mounting:

   • Solder the device onto the PCB following the recommended soldering profile to ensure reliable connections and prevent thermal damage.

9. Testing:

   • After assembly, test the device to ensure proper operation. Check for correct input-output behavior and verify that the protection features are functioning as expected.

For detailed specifications and additional information, refer to the datasheet provided by the manufacturer.

(For reference only)