Details

---

BUY MT25QL01GBBB8E12-0SIT https://www.utsource.net/itm/p/11721254.html
IC FLASH 1G SPI 133MHZ 24TPBGA

Parameter	Description	Value
Part Number	Full Part Number	MT25QL01GBBB8E12-0SIT
Type	Device Type	Serial Quad SPI Flash Memory
Capacity	Storage Capacity	1 Gb (128 MB)
Organization	Memory Organization	16,777,216 x 8 bits
Vcc Range	Supply Voltage Range	1.7 V to 3.6 V
Operating Temperature	Operating Temperature Range	-40°C to +85°C
Data Rate	Maximum Data Rate	133 MHz (133 MB/s)
Package	Package Type	WSON-8 (4x5 mm)
Pin Configuration	Pin Count	8
Interface	Interface Type	Quad SPI (QSPI)
Write Protect	Write Protect Feature	Hardware and Software Write Protect
Endurance	Endurance Cycles	100,000 Program/Erase Cycles
Retention	Data Retention	20 years at 25°C
Security	Security Features	Read/Write Protection, Unique ID
RoHS Compliance	RoHS Compliance	Yes
AEC-Q100 Qualification	Automotive Grade	Qualified

Instructions:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the specified range of 1.7 V to 3.6 V.
   • Connect the Vcc pin to the power supply and GND pin to ground.

2. Interface Connection:

   • Connect the CS# (Chip Select), SCK (Serial Clock), IO0, IO1, IO2, and IO3 pins to the corresponding SPI interface on your microcontroller or system.
   • Set the CS# pin low to select the device for communication.

3. Initialization:

   • After powering up, send a Reset Enable command (66h) followed by a Reset Memory command (99h) to initialize the device.
   • Verify the device status using the Read Status Register command (05h).

4. Read Operations:

   • Use the Read Data command (03h) for standard read operations.
   • For high-speed read, use the Fast Read command (0Bh) or the Dual Output Fast Read command (3Bh).

5. Write Operations:

   • Before writing, send a Write Enable command (06h).
   • Use the Page Program command (02h) to write data to the memory.
   • After writing, send a Write Disable command (04h) to prevent accidental writes.

6. Erase Operations:

   • Send a Write Enable command (06h) before erasing.
   • Use the Sector Erase command (20h) to erase a 4 KB sector.
   • Use the Block Erase command (52h) to erase a 64 KB block.
   • Use the Chip Erase command (C7h) to erase the entire chip.

7. Write Protect:

   • Enable hardware write protect by connecting the WP# pin to Vcc.
   • Enable software write protect by setting the appropriate bits in the Status Register.

8. Security:

   • Use the Read/Write Protection commands (2Ah and 2Bh) to secure the memory.
   • Access the Unique ID using the Read Unique ID command (4Bh).

9. Error Handling:

   • Monitor the status register for any errors during read, write, or erase operations.
   • Check the busy bit in the status register to ensure the device is not busy before initiating new commands.

10. Storage:

    • Store the device in a dry, cool environment to ensure long-term reliability.
    • Avoid exposing the device to extreme temperatures or humidity.

For detailed specifications and advanced features, refer to the datasheet provided by Micron Technology.

(For reference only)