Details

---

BUY G5017B11U https://www.utsource.net/itm/p/11728634.html

Parameter	Value	Unit
Part Number	G5017B11U	-
Type	Bipolar Junction Transistor (BJT)	-
Configuration	NPN	-
Collector-Emitter Voltage (Vce)	500	V
Collector-Base Voltage (Vcb)	500	V
Emitter-Base Voltage (Veb)	6	V
Continuous Collector Current (Ic)	17	A
Continuous Base Current (Ib)	2.5	A
Power Dissipation (Ptot)	150	W
Operating Temperature Range	-55 to 150	掳C
Storage Temperature Range	-65 to 150	掳C
Transition Frequency (ft)	3	MHz
DC Current Gain (hFE)	10 to 70	-
Package Type	TO-247	-

Instructions for Use:

1. Handling:

   • Handle the transistor with care to avoid damage to the leads or the body.
   • Use proper ESD (Electrostatic Discharge) protection when handling to prevent damage from static electricity.

2. Mounting:

   • Ensure that the mounting surface is clean and flat.
   • Apply thermal compound between the transistor and the heat sink to improve thermal conductivity.
   • Tighten the mounting screws to the recommended torque to ensure good thermal contact without causing mechanical stress.

3. Wiring:

   • Connect the collector, base, and emitter terminals correctly according to the circuit diagram.
   • Use appropriate wire gauge to handle the current ratings of the transistor.

4. Operating Conditions:

   • Do not exceed the maximum ratings for voltage, current, and power dissipation.
   • Ensure that the operating temperature remains within the specified range to avoid thermal runaway.

5. Storage:

   • Store the transistor in a dry, cool place away from direct sunlight and extreme temperatures.
   • Keep the transistor in its original packaging until ready for use to protect it from moisture and static.

6. Testing:

   • Use a multimeter or transistor tester to verify the functionality of the transistor before installation.
   • Check for continuity and resistance values to ensure the transistor is not damaged.

7. Troubleshooting:

   • If the transistor fails, check for overvoltage, overcurrent, or overheating conditions.
   • Replace the transistor if it is found to be faulty and recheck the circuit for any issues that may have caused the failure.

(For reference only)