Details

---

BUY STM32F722RET6 https://www.utsource.net/itm/p/11741580.html

Below is the parameter table for the STM32F722RET6 microcontroller, followed by some basic instructions for its use:

Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	VDD	1.7	3.3	3.6	V	Operating voltage range
Core Clock Frequency	fCPU	-	216	-	MHz	Maximum CPU clock frequency
Flash Memory Size		-	512	-	KB	On-chip Flash memory size
SRAM Size		-	256	-	KB	On-chip SRAM size
Operating Temperature	Toper	-40	-	85	掳C	Operating temperature range
I/O Pins		-	144	-	Pins	Number of I/O pins
ADC Resolution		-	12-bit	-	bits	Analog-to-Digital Converter resolution
DAC Resolution		-	12-bit	-	bits	Digital-to-Analog Converter resolution
Timers		-	12	-		Number of general-purpose timers
USARTs		-	8	-		Number of USART interfaces
SPIs		-	6	-		Number of SPI interfaces
I2Cs		-	4	-		Number of I2C interfaces
USB Interfaces		-	2	-		Number of USB interfaces (OTG FS and HS)
CAN Interfaces		-	3	-		Number of CAN interfaces
Ethernet MAC		-	1	-		Ethernet Media Access Controller
Quad SPI Interface		-	1	-		Quad SPI interface for external memory
Package Type		-	LQFP-144	-		Package type

Instructions for Use

1. Power Supply:

   • Ensure that the supply voltage (VDD) is within the specified range (1.7V to 3.6V).
   • Use appropriate decoupling capacitors (e.g., 100nF and 10uF) close to the power pins to stabilize the supply.

2. Clock Configuration:

   • Configure the system clock using the internal or external oscillators.
   • The maximum core clock frequency is 216 MHz, but ensure that the peripheral clocks are set appropriately to avoid timing issues.

3. Flash and SRAM Usage:

   • The device has 512KB of Flash memory and 256KB of SRAM.
   • Optimize your code to fit within these limits, especially if you are using large data structures or libraries.

4. Peripheral Initialization:

   • Initialize the required peripherals (USART, SPI, I2C, etc.) using the STM32 HAL (Hardware Abstraction Layer) or standard peripheral library.
   • Ensure that the correct GPIO pins are configured for each peripheral.

5. Interrupt Handling:

   • Set up interrupt handlers for real-time processing.
   • Use the NVIC (Nested Vectored Interrupt Controller) to prioritize and manage interrupts.

6. Debugging:

   • Use a JTAG or SWD (Serial Wire Debug) interface for debugging.
   • Connect to the debug pins (SWDIO, SWCLK) and use a debugger tool like ST-Link.

7. Temperature Considerations:

   • Ensure that the operating temperature is within the specified range (-40掳C to 85掳C).
   • Provide adequate cooling if the device is expected to operate in high-temperature environments.

8. Programming and Flashing:

   • Use a programmer tool like ST-Link to flash the microcontroller with your firmware.
   • Verify the programming using a checksum or read-back operation.

9. Documentation and Support:

   • Refer to the STM32F722RET6 datasheet and reference manual for detailed information on registers, configuration, and advanced features.
   • Utilize STM32CubeMX for generating initialization code and configuring the microcontroller.

By following these instructions, you can effectively use the STM32F722RET6 microcontroller in your embedded projects.

(For reference only)