Details

---

BUY TDA75616EP-HLX https://www.utsource.net/itm/p/11778841.html

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	Vcc	4.5	-	18	V
Quiescent Current (Standby)	IQ(standby)	-	20	-	渭A
Quiescent Current (Oper.)	IQ(oper.)	-	20	-	mA
Output Power (1% THD+N)	POUT	-	2.5	-	W
Signal-to-Noise Ratio	SNR	-	90	-	dB
Total Harmonic Distortion	THD	-	0.03	-	%
Input Sensitivity	VIN	-	200	-	mVrms
Frequency Response	fR	20	-	20k	Hz
Channel Separation	CS	-	60	-	dB
Operating Temperature	TOPR	-40	-	85	掳C
Storage Temperature	TSTG	-40	-	125	掳C

Instructions for Use

1. Supply Voltage:

   • Ensure the supply voltage is within the range of 4.5V to 18V.
   • Use a stable power source to avoid fluctuations that could affect performance.

2. Quiescent Current:

   • In standby mode, the quiescent current is approximately 20 渭A.
   • In operational mode, the quiescent current is approximately 20 mA.

3. Output Power:

   • The typical output power is 2.5W with a total harmonic distortion of 1%.
   • Ensure the load impedance is suitable for the output power to avoid damage.

4. Signal-to-Noise Ratio:

   • The signal-to-noise ratio is typically 90 dB, ensuring high audio quality.

5. Total Harmonic Distortion:

   • The total harmonic distortion is typically 0.03%, providing clear and clean audio output.

6. Input Sensitivity:

   • The input sensitivity is 200 mVrms, which is the recommended level for optimal performance.

7. Frequency Response:

   • The frequency response ranges from 20 Hz to 20 kHz, covering the audible spectrum.

8. Channel Separation:

   • The channel separation is typically 60 dB, ensuring minimal crosstalk between channels.

9. Operating Temperature:

   • The operating temperature range is from -40掳C to 85掳C. Ensure the device is used within this range to prevent thermal damage.

10. Storage Temperature:

    • The storage temperature range is from -40掳C to 125掳C. Store the device in a dry and cool place to maintain its integrity.

11. Installation:

    • Follow proper PCB layout guidelines to ensure optimal performance and thermal management.
    • Use appropriate decoupling capacitors near the power supply pins to filter out noise.

12. Handling:

    • Handle the device with care to avoid static discharge and physical damage.
    • Use anti-static wrist straps and mats when handling the device.

13. Testing:

    • Test the device under controlled conditions to verify its performance parameters.
    • Use a multimeter to check the supply voltage and quiescent current during testing.

14. Troubleshooting:

    • If the device does not function as expected, check the power supply, connections, and load impedance.
    • Refer to the datasheet for more detailed troubleshooting steps and contact the manufacturer if necessary.

(For reference only)