Details

---

BUY MBRS2H100T3G https://www.utsource.net/itm/p/12353629.html

Parameter	Symbol	Min	Typ	Max	Unit	Condition
Average Rectified Output Current (Non-Repetitive)	IF(AV)	-	2.0	-	A	TA = 25掳C, f = 50/60 Hz, CL = 10 渭F
Peak Repetitive Reverse Voltage	VRSM	-	-	100	V	TJ = 25掳C
RMS Reverse Voltage	VRMS	-	-	70.7	V	-
Forward Voltage at Rated Current	VF	-	1.1	-	V	IF = 2.0 A, TJ = 25掳C
Peak Forward Surge Current (Non-Repetitive)	IFSM	-	80	-	A	tp = 8.3 ms, sinewave, TJ = 25掳C
Junction Temperature Range	TJ	-55	-	175	掳C	-
Storage Temperature Range	TSTG	-55	-	150	掳C	-
Thermal Resistance, Junction to Case	R胃JC	-	10	-	掳C/W	-

Instructions for MBRS2H100T3G

1. Handling and Storage:

   • Store the device in a dry, cool place to prevent moisture damage.
   • Handle with care to avoid mechanical stress or damage to the leads.

2. Mounting:

   • Ensure proper alignment of the leads during soldering to avoid misalignment and potential short circuits.
   • Use a heat sink if necessary to manage thermal dissipation, especially under high current conditions.

3. Soldering:

   • Soldering temperature should not exceed 260掳C for more than 10 seconds.
   • Avoid excessive heating which can cause damage to the device.

4. Electrical Connections:

   • Ensure that the polarity is correct when connecting the diode to the circuit. The cathode (bar) and anode (no bar) must be connected correctly.
   • Use appropriate wire gauge to handle the rated current without excessive voltage drop.

5. Thermal Management:

   • Monitor the junction temperature to ensure it stays within the specified range to prevent thermal runaway.
   • If operating in high ambient temperatures, consider additional cooling methods such as forced air or heat sinks.

6. Surge Current Handling:

   • The device can handle peak forward surge currents up to 80A for a short duration (8.3 ms). Ensure that any surge currents do not exceed this limit to avoid damage.

7. Reverse Voltage Protection:

   • The maximum reverse voltage should not exceed 100V to prevent breakdown and potential failure of the diode.

8. Testing:

   • Use a multimeter to verify the continuity and polarity of the diode before installation.
   • Perform functional tests after installation to ensure the diode is operating correctly.

9. Compliance:

   • Ensure that the device meets all relevant safety and compliance standards for your application.

10. Documentation:

    • Refer to the datasheet for detailed specifications and additional information.
    • Keep a record of the part number and batch for traceability and warranty purposes.

(For reference only)