Details

---

BUY INA828ID https://www.utsource.net/itm/p/12379186.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	-	-0.3		6.5	V
Input Voltage Range	VIN	Relative to each input	-0.3		VDD+0.3	V
Output Voltage Swing	VOUT	No load, RL = 10k惟	0		VDD-1.5	V
Quiescent Current	IQ	VDD=5V		400		渭A
Input Offset Voltage	VOS	TA=25掳C	-150	0	150	渭V
Common-Mode Rejection Ratio	CMRR	f=0Hz, TA=25掳C	98	100	102	dB
Power-Supply Rejection Ratio	PSRR	f=0Hz, TA=25掳C	90	95	100	dB
Bandwidth	BW	G=1, VDD=5V		1.2		MHz
Slew Rate	SR	VDD=5V		0.5		V/渭s

Instructions for INA828ID

1. Power Supply Configuration:

   • Ensure the supply voltage (V_DD) is within the specified range of 0V to 6.5V.
   • Avoid connecting any input or output signals outside the power supply rails to prevent damage.

2. Input Signal Handling:

   • The input voltage should not exceed the supply voltage plus 0.3V or go below -0.3V relative to the input pins.
   • For optimal performance, keep the common-mode voltage within the operational limits.

3. Output Load Management:

   • The output can swing from 0V to V_DD - 1.5V under no-load conditions or with a 10k惟 load resistor.
   • Be cautious with heavy loads as it may limit the output swing.

4. Biasing and Stability:

   • The quiescent current is typically around 400渭A at a supply voltage of 5V. Ensure this is accounted for in power budget calculations.
   • Use appropriate bypass capacitors near the power supply pins to maintain stability.

5. Offset Voltage Compensation:

   • The input offset voltage can vary between -150渭V and 150渭V at room temperature. Consider using an auto-zero or chopper-stabilized amplifier for applications requiring very low offset voltages.

6. Noise and Interference Mitigation:

   • Take advantage of the high common-mode rejection ratio (CMRR) and power-supply rejection ratio (PSRR) by properly grounding and shielding sensitive circuits.

7. Frequency Response:

   • The bandwidth is approximately 1.2MHz at unity gain. Adjust the gain settings according to the desired frequency response characteristics.

8. Handling Precautions:

   • This device is sensitive to electrostatic discharge (ESD). Handle with appropriate ESD precautions.
   • Refer to the datasheet for detailed pin configurations and additional specifications.

(For reference only)